L-faster Bicycle Spoke Chain Wheel Bike Rear Wheel 32T Sprocket for Our Left Drive Motor Kit 16T Freewheel with Adapter for Motor MY1016Z

My e bike haven't used the geer that came with it yet but will get to it at some point wiring and alinement issues have been slowing me down

Good for the price

The lack of details, of the size of the hole for the shaft and the amount of power that can be applied.after opening the hole to fit a 3/4 inch shaft. Was able to use the sprocket for about 3 hours before it completely came apart. Will admit it was an improper use of the sprocket.

The kit is nice but the 32T sprocket hole is small. When I tried to install the sprocket, the sprocket is pushing the bearing cover and make the tire not to move. The hole should at least 2 inches in my case. I will be returning the kit and see if I can find with a bigger hole.

This is the third freewheel I have purchased from you. All of them broke apart. This is crap. I want a refund for the conversion kit, the parts kit, and the freewheel.

The freewheel sprocket broke from being spun too fast from a test run on my bicycle engine, rendering the whole setup useless. Only when I had to weld the freewheel to the sprocket would it function again. Everything else works great, however, I wish they gave you more chain links.

Came as pictured and on time

utiliser avec moteur 12 volt sur mon vélo

Molto ingegnoso per me ed è stato molto interessante montarlo comperate !!Devo montare solo il motore

One rubber clamp disk had chunk missing, large sprocket and motor sprocket adaptor were not stainless steel but ordinary steel coated black , photos of product showed different better quality items , clamp sections were three part not two part ( cemicircles ) and low quality , at the very least Amazon should ensure the description photos are what's sent , shame on Amazon for allowing L faster to sell this tat , didn't think amazon did bait and switch , don't buy until they sort it out

très bien

This kit goes well with MY1016 electric conversion. It allows for left side mounting so no need for messing with gears the bike came with stock and it's the only way to make it work with a single speed beach cruiser. I converted a mountain bike first (red one in photos) and that was more difficult because you need to remove the multi-gear from the rear wheel. You end up with just one gear in the back for pedaling anyway so might as well go with the beach cruiser to start with. The mounting plate can be cut and hammered into whatever fits with washers etc. to make it all line up. It sometimes fits well without modification if you have the right frame but don't count on it. If you mount it according to the manufacturers plan, your heel will be hitting the motor. Both of these bikes are only 24 volt 250 watt setups but move along quite well. If you are handy this is much less expensive than a factory electric bike.