5 Ton Clamp Self-tightening Frame Body Repair Small Mouth Pull Clamp 10,000lbs

I've used it a few times to pull out radiator supports with my truck and Kubota. Holds nice and tight. Does what I need it to do. For the price. I can't complain

Arrived quickly, works well. So far, I've used it to pull part of the unibody structure back into place on a 2006 Camry. It held onto the panel, didn't slip, and stood the strain of the load I put on it. I would buy again.

It done the job very well

Works good ,very happy with that purchase. It has good clamping for medium body pulls haven't tried frame pull yet. Has a nice price might buy a couple more soon

Harvey duty! It worked perfectly for my application

I had a bad accident. My passenger rear door was completely crumpled. I needed to pull it before I could take the door off and replace it. This did the job perfectly. This is not a small tool. It's extremely heavy duty. Just what you need to straighten steel.

Used to straighten the back of the trunk on a Ford Taurus that was rear-ended to fit a used lid. I have very little knowledge pf body work and this worked flawlessly. My advice would be to just go slow, it was way easier to pull it back out with a come-along than I would have guessed. I can see a use for it moving sheets of steel around in the shop as well.

needed a way to hold a round steel cup (inner cv joint axle shaft) stuck in a transmission that I could connect a 13 pound slide hammer to. nothing worked even a good vise grip. this worked and we got it out saving me the cost and work on a new transmission. Great tool for holding loads, it just does not slip.