(Pack of 3) CL01-12 Microwave Oven High Voltage Silicon Rectifiers Diodes 350mA 12kV (Replace for HVM12 HVR-1X3 T3512 T4512)

Llegó a tiempo

worked well

Affordable and good item. The only limitation was the connector's size is a little bit smaller than the original one. I had to modify a little before I could use it.

They work and are easy to install

this product does work as intended.

perfect replacement parts i needed.

All 3 pieces of the order were open (no continuity). Completely useless garbage. Don't waste your money.

I tested all three diodes using a 9 volt battery and a digital meter. If you use a 9 volt battery in series with the diode and read voltage you can test these high voltage diodes with either an analog or digital meter. This technique was shown in my Kenmore Microwave troubleshooting guide.The supplier does not define that these are shipped with a push on lug designed to only accept 0.187" wide tab. My microwave uses 0.250 width tabs so I had to remove the supplied push on female disconnect and replace it with 0.250 compatible push on disconnect. The leads on the diode were barely long enough as supplied so I had to cut apart the push on lug so I could preserve the wire length and then had to install a new female disconnect (push on lug) that would accept the 0.250 tab on my capacitor. The diode was the exact part number for my Kenmore Elite Microwave.

Todo bien, incluso llegó antes de lo previsto. Gracias!