Full Size 15m 50feet Black Sticky Car Door Edge Scratch Guard Trim Molding Protector Cover U Shape Air Vent Edge Decoration

This Edge Trim to edge the top plate on our Cargo Pod Coffee Table in the 'Space Room'It was quite difficult to attach to the plate, I had to open the seam up to get it onto the edge all around, but that was good, it meant that it would be a great seal onto that edge.It looks great !

So far this looks like a good product for my 2019 Nissan Leaf. The description shows a 3m strip you need to remove. I found that the adhesive is really in the crotch of the strip rather than on the two sides. At first I thought there wasn't any until I removed the small sample piece I tried. You’ll notice it has little bubbles when you put it on. Just press firmly towards the front of the car (assuming your putting it on the door).

I got this exact Same item (10 Years Ago) (Yes 10 YEARS AGO). That is how long ago I put it on my new Jeep and IT LOOKED GREAT. It was so EASY to INSTALL, no Mess, and no PROBLEM for 10 YEARS.I ordered again. This time- I ordered 2 rolls- BIGGEST MESS EVER, GLUE MELTING AND SMEARING EVERY WHERE, IT WAS GETTING ON EVERYONE'S HANDS and CLOTHS AS WE GOT IN AND OUT OF VEHICLE FOR WEEKS!!! YES it was getting on everyone and everything that touched the vehicle for WEEKS!!!I HAD TO REMOVE IT AND IT TOOK WEEKS TO REMOVE ALL THE GLUE AND IT COST A FORTUNE FOR ALL THE GOOP BE GONE AND CLEENERS TO GET THE GLUE OFF. I DON'T KNOW WHAT CHANGED IN 10 YEARS, DON'T BUY!!! YOU WILL BE SORRY!!! DON"T BUY, the glue ran down the vehicle and never dried!!! I want a refund, but I did use it and had to throw it away, so I guess no refund, sad.

looks good, shiny, easy to apply, but that glue inside I had to soak it in water for a few days in order to remove most of it before I applied.

Purchased this door trim in "Gloss Black" to replace the chrome trim on my motorcycle helmet. At first wasnt sure if it was going to be too large in diameter, couldnt tell size in these photos. When I received it, it was def smaller than i expected (see my photos) i went ahead and swapped out my chrome trim anyways and although it looks alot better in black, it wasnt the easiest. I suggest slightly heating it to form around curves. It comes wound in a bundle and is a little on the stiff side so it wants to retain that shape. For use on vehicles id suggest using a larger diameter molding as this will barely sit over the edge of the door. Adhesion is so so, not the greatest but its holding (havent goen through heat to see if itll unstick) decent product overall.

Adheres nice and looks good. Ty

I used it on the edge of my motorhome compartment doors, it went on easy and stayed on but I am not sure how good the glue will hold, I already have one door that the glue is not sticking.

This door guard looked good on my RAV4 2021. This review is more for buyer awareness. This is only adhesive no metal clips to fully secure the rubber strip. The installation was easy and straight fwd. after a month I started to notice the strip was starting peel off and all the dirt from road was accumulating under the strip. This caused the strip to ultimately loose adhesion and fail. I ended up loosing two strips. I finally decided to pull it all out and what you see is the end result with picture. The adhesive was stubborn to removed no amount of power washed helped. I had to spend another 20 usd for googone to removed the residue.

This product fit the edge of the glass on my travel trailer perfectly hope it works to save glass for getting broken

Packaged well and the quality seems to be good.

Glue is melting and messing up everything!

This was excellent for my needs and arrived quickly

Easy installation good protection for your car door and trim looks good