CHANCS DC Worm Gear Motor 370WG 12V DC 0.6RPM Inversion Reducer for Automation Equipment

This heavy little unit is really solidly built and oozes quality.You get a metal housing with the top shaft sticking out the top that has a M3 internal thread. The motor has two small solder terminals, positive marked with a red dot.Wire it up to 12V and it will rotate clockwise at around once every two minutes. It's almost silent in operation and there's no vibration. It's got quite good torque, so as long as you balance it right, you'll have no issues.Reversing the polarity changes direction, and adjusting the voltage will affect the speed (within reason - I didn't want to over drive it, or run too low a voltage that it would burn out).There are M3 holes on the 'top' (same side as the shaft output) for mounting. Holes underneath would have been nice, or at least a flange or two.

Works wellHigh revolution

Bought to replace one I had ordered earlier that had too high a gearing, at 100rpm, for my requirements. This one is 375rpm and is now perfect for my needs.

I purchased this worm gear motor for a little project. It came in a plastic bag and is nice and small. I will write back if this does not last a year, but so far it seems like a great "little" find.

Dieser Schneckengetriebemotor passt sehr gut als Antrieb für ein Mühlrad in einer Mühlen -Krippe

Ottimo prodotto va benissimo

定格は12Vですが２Vくらいでも十分に動きトルクもそれなりに。　これを使って小さな（500ｍｍ角くらいの）ソーラーパネルを太陽追尾で回しています。５Ｖで。

I'm using it with a lead screw to provide linear force. A simple DPDT (on-off-on) switch provides reversible motion. Gearbox looks like a robust build. It would be useful if they added an axial load limit to the spec. sheet (I ended up adding thrust bearings to the lead screw to protect the gearbox). I also bought one of the 10 RPM motors.