Genuine Dodge RAM Accessories 82211694AB Fog Light

The hardware was nice but the lens on one of the fog lights was broken. I really desired a set of these lights and I went through the dealer and purchased a set that was in perfect condition. If you can get a set that was not man handled and in good condition I would defiantly recommend these lights. THe light output is great !!!

Ordered this to add to my 2010 Ram 1500. These kits are getting scarce. I am hesitant to return it because I might not see one again.In the box is everything pictured in the instructions EXCEPT the headlight switch. I researched the part number prior to purchasing to ensure that the switch was included in the kit. Now I’m torn between sending it back, or coughing up another $60 at the dealer for the headlight switch to make the kit complete.I installed this in a 2010 Crew Cab, and it did require programming by the dealer.

The installation took less than 30 minutes. My truck needed to be programmed in order for them to work and I had the local dealer perform this during some scheduled maintenance (make sure you keep the installation manual handy because my dealership needed the code to program them). The lights make a big difference and I'm very happy with the purchase.

Works great, had to have dodge turn them on in the computer before they would woke

I bought this kit and the install was a bit convoluted but I eventually got it done. Problems I have with this is that The switch that you replace lights up blue whereas my dash lights are green. Secondly only one foglight works after wiring them up... I brought the truck to the dealer and they stated it was the wiring. I contacted the seller and they would not exchange the part.

Easy to install, even came with a replacement headlight switch. However the lens seal and bulb seal are not that great.. less then a year after installing them and I had 1 light housing full of water, the reflector is now dull due to this.

Wiring instructions are wrong but the lights work great.

Wiring instructions seem to be for 2009 and 2010 trucks as the green C3 connector they instruct you to put the wires in is already being used. on my 2012 Ram 1500. Apparently there was a different TIPM box installed in the 2011 model year. so you are required to use the grey 16 pin connector to hook up. It would have saved me considerable time researching on line if those instructions had been included. Also not sure how effective the lights are going to be as the licence plate blocks part of both lights.. May have to move the plate some how .I still have to get the Ram dealer to put in the code to see if they work.