ACI 174347 Windshield Washer Pump

This item fit perfectly, worked as advertised. Form, fit, and function was excellent

Easy peasy on my 2004 Wrangler. Only problem was the new gasket doesn't fit, so I leaked all my old fluid out and then had to reuse my old gasket. I removed my tank but in hindsight the easy way to do this is just to put a bucket under the Jeep, pull the old motor and jam the new one end. You need to remove the radiator overflow tank to make this easier, which is a 5 second tool-free job

Installed this pump on a Jeep TJ.Installation is easy as the old unit pulls out of the washer reservoir and the new one snaps in with the included gasket. The wiring is not a direct replacement from OEM though. The wiring harness plugs into the factory plug but must then be connected to the pump motor. The motor is unmarked and there is no direction on how to hook it up. I just hooked it up and if it runs but doesn’t pump water, reverse the wires at the motor.Overall, this is a great replacement that works great.

This pump works great for me. Easy to replace. If you put the wires on the wrong terminals, just swap them. No, it doesn't come with instructions. Most automotive replacement parts don't. If you need help call a friend or check youtube. I am sure there is a video on how to replace a Jeep windshield washer pump.I will say, you can do it fast and dirty without removing the washer tank or you can do it cleaner and neater by removing the tank. It is up to you. The tank is only three bolts and you can clean it out while it is out.

Used this on a 2017 389 Pete. Fit and performed as the original with exception of the electrical plug. The wiring on this part is made to work on numerous applications. Cut the plug off the old one and attach to the new one or cut the plug on the truck and match to the new one. Pretty basic.

The grommet provided with this pump was too small for my 2003 Jeep TJ Wrangler Rubicon.I didn’t realize this until after I had installed the pump, reinstalled the reservoir and filled it up with a gallon of wiper fluid. I wasted about 3/4 of a gallon of fluid while I removed the pump, swapped the new grommet with the old grommet and reinstalled the pump.On a brighter note, the electrical connections fit and the pump works.Luckily, I still had the original grommet and it was in pretty good shape.Wasted about $4.00 of fluid though.If the grommet were the correct size, this would be a 5-star review across the board.

I installed this on a single pump 04 Jeep Wrangler. I bought a replacement that came with a new reservoir from another online source a few months back but within a couple months that pump went out. So not needing the reservoir I went looking for the pump alone. I picked this one and so far it's been a good buy.The install was easy but the included rubber grommet did not fit and leaked badly. However the one that was on the pump that burned out fit great and made the new pump seal tight. It's been several days now and I still have no leaks.So far I'm very happy and if anything changes I'll be sure to update this.

Great product