HilitandHigh Performance Urethane Round Belting, PU Transmission Belt Polyurethane Round Belt for Drive Transmission Green 3mm x 10m

Great product , have not used yet but perfect for my needs.

This works super great for rock tumbler belts. Just be sure not to tight. Not enough give will destroy the roller bushings. Other then that I have been running one belt constant for over a month. I used a soldering iron with a flat tip to heat. Held each end of belt each side of tip then when started to melt i slid both ends together and held till cool. Be sure to get them even to keep the belt from jumping.

Splicing took me a couple trys to achieve a solid bond, but works great.

Easy to weld. Very good strength!

La utilicé para un motor de que un pantografo tridimensional, tiene 3 meses funcionando y va muy bien!

I was a little nervous about "ease of welding" claim but it worked just fine. I was building a drum carder for my daughter. My setup:razor blade in vise gripsplywood with hole slightly bigger than beltmounted both in bench clampheated razor until red with torchpressed belt to both sides of razorput each side into plywood hole and pushed together for 1 mincut away plywoodTook me 3 tries to get it damn near perfect. Make sure the joint ends are perfectly 90 degrees.

The media could not be loaded.  Simply cut, heat, press ends together and then after it cools cut the excess off (I used a Bic disposable razor cartridge) and sand it down a little, and it’s ready to go!

This stuff is so fricking fun to use. I made belts for junk that doesn't use belts???? Really???Yes. My bench grinders do not need belts but I lined up three bench grinders back to back and made a belt to go from one powered up unit (AFTER it's set up) to the bench grinder behind it.The first grinder was easily able to spin both grinders simply by wrapping the belt around each 1/2" shaft melting the ends together, then powering on the first grinder.I WAS AMAZED! It really worked. the belts did not get loose and they did not break???? I ran it for 30 minutes and not a single damn problem. Why can't everything work like this.Great stuff. I'll keep it around my shop always now.

Melt the ends together to make a very strong belt.

This stuff blows my mind, AMAZING,easy to use and super tough

Glad I discovered this stuff. I created a couple of belts for 2 old movie projectors. Melted the cuts together with an old soldering iron with a spade tip. Tested for strength & was impressed with the solidity. I made a little jig to hold the ends together but in the end just lining them up by eye (with good magnification ) would work fine. The slight bulge after fusing the ends together can be trimmed with an exacto & fine sandpaper.

Pas utiliser encore

I used this to fix my Braun 4-171 Food Processor ( its over 40yrs old ). hahahahahaTry googling that one. Not even specialty stores holding old parts would help. hahahahaThe good old days when things were built to last. $29.00 instead of spending $500.00 for a new one.