Seymour 16-1203 Hot Spot High Temperature Paints, Black

I used this paint on a grill. I did do some normal prep work like degreasing, washing, very light sanding. The paint went on nicely with good coverage and dried very fast. When everything was dry I was left with a nice even coat and was able to do a seasoning burn-in for the grill interior, the grill reached temps upwards of 700 degrees with no issues for the paint. I would say that after the initial heating the paint darkened and maybe even hardened more so. The old grill looks new again thanks to this stuff.

Easy to use covers great

Great product w/ many uses. I refreshed an old pot.

I bought this to repaint a wall heater that was rusting.The paint itself is a little on the weak side requiring multiple coats.Instructions on the can are a little vague.The instructions call for curing at 400 degrees but it does not say for how long or if needed after each coat.Use in a well ventilated place as it's a little fumy.An aerosol gun/handle will also help as the spray tip is a little harder to push down than most other pray paint cans.

Holds up great

I bought this for my stove hood. It had seen better days for sure. Prepped and sprayed, which went on very easy and clean. I did a couple of layers, but it went on good. I now have a brand new hood.

I have not really tested in a really high heat situation yet mainly because it comes out of the can looking more like a white speckled cloudy liquid. At first I thought that it needed a lot more shaking. I shook it for maybe 10 minutes at a time several times during the day and yet it still came out the same. The result was that it barely covered most of what I sprayed. I tried light I tried heavy and maybe after 4 or 5 coats and not getting anywhere near covered I sort of gave up and sprayed way too much creating a puddle that I let sit for a few minutes and then smeared over the areas that were not being coated. I then hit it with a hot gun a few hours later. That seemed to cover everything after a few more coats but at the pace I am going through this can I do not imagine that you would be able to cover a 12 inch by 12 inch piece of metal with a solid coat.Also while smearing it around seemed to work in terms of covering what I am painting it did not leave a neat looking job. It is quite a mess actually but for this test application it is the best that I can do to see if it can withstand high heat as it says it could. It held up well to the heat gun set to high but I did it more to heat the surface making it more set so that subsequent coats might hold better.

Easy to use.