ZAGG - InvisibleShield Ultra Clear - Military Grade Film Screen Protector - Made for Samsung GS10 - Case Friendly

Followed the instructions and at the end I did have a few small air bubbles and one large one. I itially I was disappointed, however left it on because the sheerness is better than the original Samsung, After 24 hours the small air bubbles had disappeared, I wasn't sure at the time but it seemed like the large air bubble was getting smaller. I woke up 3 days after installation and the large air bubble had disappears well.It does advise the reset the fingerprint recognition however I didnt and it actually seems more responsive than before. I was recommended this by a friend and he was right, wish I'd done it months ago.As for long term im not sure, and I dont plan on testing the protective nature. Will edit if I do drop the phone.

The height is at least 5 mm shorter than the screen and this is very noticeable. It is too stiff to fold around the width of the screen and just looks silly. The sides will catch and cause the screen protector to be ripped off. Trying to install it is a frustrating task, filled with many bad words. The bottom layer is obvious and you take it off to stick a dust removal layer on. That part is fine. Then trying to lift the topmost (screen protector) layer from the below dust removal layer is only possible by sticking your fingers onto the sticky bit of the screen protector whilst trying to remove the dust removal layer, which does not split in half like they think it does. You are left with loads of bubbles and a screen protector that does not fit. I do not have the patience to wait for the bubbles to go. I've thrown the whole lot in the bin and will risk my finger-print feature with a tempered glass protector.

Absolutely poor quality item. Once fitted, following all the instructions meticulously, the screen appeared with multiple lines all over the screen underneath the protector. The lines came up after the use of the card to remove air bubbles. I would like to claim a refund but I cannot return the item since it has been used.Moreover the size of the protector is smaller than the screen of samsung galaxy s10. If you align the top, the bottom will be too short.

Terrible product. First of all this does not fit! Width is fine but missing about a quarter of an inch in length. Not that this would matter however. The application process comes with poor instructions resulting in a garble of numbered tabs and the screen protector remaining stuck to the applying plastic. This is the first review I have left on amazon in ten years of using it but given how disastrous this product is simply had to post it. I will be asking for my money back immediately.

bought this based on reddit recommendations that it would be a good replacement for the original samsung screen protector (not to be found anywhere). it's not! it's the same silicone kind of flimsy film that is a pain to apply (didn't work for me)

Box said it was glass like feel and clarity, well the flimsy plastice cover a recieved was far from glass like.I read the instructions and watched video for applying protective cover but nothing seemed to go right. The tabs did not pull off as per video. I even wondered if I had received a fake item. Waste of £15 as screen did not get fixed to phone.

It did not fit on curved screen like it claims. It didnt last 5 minutes on my phones because the bubbles would not rub out. The applcation method is absolutely mental. The way it has to be done in two halves leaves a channel of bubbles horizontally through your phone screen. Not worth the money at all 20 quid i paid and threw it straight in the bin.

Terrible product. Not easy to install and when it's installed has a horrible texture with loads of air bubbles. Not as advertised and not 'glass-like' at all. Do not purchase!