PowerTec70139 6-to-1 Hose and Fittings Reducer Adapter

It's a pretty basic component, but it doesn't have to be complicated. I needed connection between 6" and 3" trunking to accomodate an inline blower, so a quick slice with the hacksaw and it was fitted into the project. No worries about nasty fumes from that resin printer, this simple plug in venting system has it covered.

I recently picked up a vintage 113 Craftsman 12” bandsaw circa 1984. It was in great shape and mostly complete. One of the two things missing was the dust port elbow. This is a great replacement. The smaller end clamps perfectly in the dust port and the larger end fits my 4” dust collection system. So this is actually better than if the original elbow was in place. I’d either have to replace the elbow anyway with a piece like this, or attach an adapter to the original elbow which is another 90 degree turn.

Sturdy and works great.

The 6" diameter fit perfectly over my 6" heating/cooling ductwork. I cut off the top 3 reducing pieces with a hacksaw since I needed the 3" reduction. The 3" diameter fit well with the 3" duct. The clamps did their job on both ends.

ok