Specification: Material: Carbide Flutes: 2 Flute Shank Diameter: 3.175mm (1/8") Cutting Diameter: 3.175mm (1/8") Cutting Edge Length (Flute Length): 12mm Total Length: 38.5mm Quantity: 1pc Features: High-density polished, wear-resistant, high temperature. High cost-effective, improve efficiency. Mainly used in cutting and engraving. Can be engraved Copper, Aluminum ,ABS, Acrylic, PVC, Wood, most plastics ect.. Package Included: 1 x Ball Nose End Mill
A**I
Value for money.
It's a value for money item. We used the 8mm bit on a 12mm glass. It was able to do the job. Keeping the bit cool with a jet of water is essential to avoid burning/damage to the bit. With little patience and right technique I am sure it can take care of most usual tasks.
V**A
Quality could be better
Very cheap quality. The steel coating was peeling off and was already rusting when I received. I used a bit to cut glass. The diamond coating went off and became blunt after four to five uses.
G**N
Good
Bigger bits are good... Smaller bits got burnt..
M**L
Do not purchase any product online if you want quality product.
Very poor & werst quality .Only one time usable.Not possible to drill 2nd drill in the ceramic or marble.
B**K
Poor quality
I had purchased this with great expectation and turned out to be highly inferior quality hence returned.
A**.
Could Not solve our problem
We tried to drill hole in tile and it could not, so quality is not upto the mark, means useless
B**A
Great product
Done my job very efficiently. Value for money. Must buy.
A**M
Not bad
Not bad
Trustpilot
1 day ago
3 weeks ago