DB Electrical 160-01008 Ignition Coil for Briggs & Stratton Fits models 133202, 133702, 135202

Bought this for 1978/1979 Till n’ Plow front tine roto tiller. Engine is 5hp Briggs and Stratton Serial Number 130202. Mounting holes lined up perfectly at about 2 and 5/16” center to center. Used air gap of.010 to match air gap of previous ignition coil. Started right up and runs perfectly. Spark plug wire was the perfect length for spark plug located on top of engine. Didn’t use extra wire that was connected to old ignition coil.

After some research I found out that I could put an updated magneto / coil on my 5hp horizontal shaft Briggs. My rototiller had lost spark from sitting for a few years without being started. So after figuring out that I could put electronic ignition on it and eliminate the points and condensor it was game on! I took it all apart, pulled the flywheel, cut the wire going to the condensor and bolted on the new magneto and set the gap between the magneto and flywheel to around .010". Put it all back together and it started within the 2nd pull! In the past I bought a voltage regulator from this company for my Arctic Cat and it worked great. I thought I would buy from them again. I'm very pleased with them and this product! I recommend highly!

works fine for the money!

I bought this part for a Wizard rototiller. It was an exact fit, and solved my ignition problem. I wish it came with the plug boot though; I ended up getting one separately.

Ended up ordering one from Briggs & Stratton.

My California trimmer is an older one with a 5hp briggs and stranton engine and I bought this because it stopped giving a spark. I received it and installed it with a .08 gap. It started right away and has been working flawlessly so far.

I needed a replacement for an old snowblower I had and this coil fit the bill. It came to me quickly and wasn't all wrapped up in 2 miles of bubble wrap. A really good price and was just as the picture said it would be.

Received this ignition coil for an older Briggs and Stratton motor in timely manner. Part was an exact fit with mounting and same terminals for kill switch like original coil. Very pleased with this purchase.

Did not fit my engine

Produit conforme, s'adapte correctement sur mon moteur Briggs and Straton. Rien à dire.

Cette bobine a parfaitement fonctionné sur moteur Briggs & Stratton 5HP 1979 pour remplacer l'ancienne configuration des des pointes et condensateur , le tout fonctionne électronique .

pour mon motoculteur equipé d'un moteur brigg&sttratton 5hp.

Ordered for my dad who does small engine repair as a hobby...he said it will work but that the holes aren't in quite the right spots so he'll have to alter them a bit. I've noticed similar said in other reviews.