WORKER Motor High Power Ball Bearing 43000 RPM for Nerf Stryfe Rapidstrike

So far so good! Works fine out of the box, ~4000kv measured using PSU and rpm meter. Installed in FMS Max Smasher monster truck. Should be around same speed, if not slightly more than FMS Speed motor. Has bigger can than stock, beefy magnets. Got 9mph. However, had to trim output shaft a few mm to clear transmission servo. Also, if you get stuttering under acceleration upgrade your battery (>30C). Crazepony 400mah 2s battery worked well for me but you have to change connector on the truck to JST.

Very good

Perfect for an rc vehicle@ 1/12 scale motor barely gets hot on 2s lipo. Very efficient on current would definitely purchase again.😎👍👍👍👍👍

I really like these motors...I have used these motors for about 3 yesrs in slotcars for drag racing.

says it fits inside a stryfe, seller says in comments itll fit into a stryfe but no you will have to cut yours so you might as well go with 180 motors instead of these if you want motors for your stryfe.

Clearly used motors. Terminals are all broken off so I have no way to connect power to see if they even work, scratched up and covered in glue

Put them in a mod for stryfe it worked with 2s but when i left it alone no battery hooked up at all my rewire was perfect but the motors died! Nothing worked and i changed to worker 132s and my stryfe works no problem. If i got to pay this much for motos they should work. Will be contacting your company soon.Edit: i actually fixed these now they wotk as intended not bad motors