Directed Electronics514LN Revenger Soft-Chirp Siren

This is an excellent siren and I recommend clipping out all the other sounds. Will help distinguish yours from every other alarm out there. Sadly car alarms going off are so previlant that people fail to pay attention. So make it louder. If you have a car, mount one in the front under the bumper somewhere. Not by the hood. Your engine will dampen the sounds (yes even if it’s not running because it’s blocking the path of sound). Then mount one under the rear bumper. USE A RELAY TO CONTROL BOTH SIRENS FROM THR ALARM PORT. FAILING TO DO SO WILL AND CAN FRY YOUR ALARM.If you have a truck, I have a 4th gen Ram and mounted the front siren on the inside of the grill. Very loud. Then mounted the other one in the back under the bed on thendriverse side behind the tire and splash guard. Points straight down and makes the alarm even louder. Be creative and hide the siren so it can’t be seen and disabled by cutting or breaking the wire/siren. But make sure you can get a clear shot down and the sound hits the ground and reverberates outwards.These are cheap sirens and work great. Especially if you run 2 remember, USE A RELAY AND USE THE SIREN OUTPUT FROM THE ALARM TO CONTROL THE COIL OF THE RELAY. GROUND THE OTHERNSIDE OF THE RELAY. THEN CONNECT THE FRONT AND REAR SIREN TO RELAY OUT. Obviously fuse relay source so that the load is also fixed. Fuse close to the battery as possible so if you pass through firewall and happens to cut wires and shorts over time it won’t start a fire or cry your electronics.

My old alarm went out. I replaced this one with the old one. This is a very loud speaker. Works great on my car.

Excellent item!I was guessing that my speaker was the problem on the car alarm, simple and fast repair!!!

works fine, loud and clear

I have a viper alarm on my 89 Ford Bronco and the speaker stopped working so I swapped it out with this speaker. Super easy swap. I unplugged car battery. Always disconnect Negative(black) terminal first then disconnect positive(red). Then I Cut old speakers wires and dismounted old speaker. Then connected new speakers wires where old wires were connected and then mounted speaker where old one was mounted. LAST BUT NOT LEAST!!! ALWAYS connect the RED battery terminal first and then the black when you are hooking it back up. Whalaaa🤙🏻 Speaker also sounds great 👌🏻

Unreal that much sound out of that small siren. Good price good product like Amazon.

Super siren! Easy to install. Small, but very shrill!!!!

Nice and loud