PowerGrip SB Thermoplastic Hose Clamp

This new way to fix a garden hose is fantastic. As you can see in the picture the old way left sharp edges and looked bad. Using these power grip heat shrink tubes is a great looking solution and works. My hose OD measured 22mm so make sure you get the right size.

They look great, no cuts, no ugly hose clamps, work great

Many hose clips ruin your hoses and to be honest get tightened too tightly. Also metal bands don’t conform as well. These conform to any shape and you cannot over tighten them....only deal is....get your setup right as they don’t come off without cutting them....also easier to fit when you can get your heat gun all around them....watch the video on utube before you try to use them.....easy to get out of their shipping tubes!.....just crush the thing and pull the tube out. If you need to remove any hoses regularly I’d use a standard hose clamp in that area.

these things are awesome. i replaced the clamps on my heater, water pump and bypass on my ford 302 and it is such a cleaner looking engine now. i highly recommend. i purchased a few different sizes so i had some on hand. make sure you measure the OD with the hose in place as the barb will bulge the hose some. apply plenty of heat. per manufacturer, you can't over shrink them. the other great thing, is if you're using it on a line that gets hot, it'll tighten down anything that wasn't fully clamped once its at operating temp.

last time i got a box. you should be clear what your selling those arnt worth $5 each

Did the job. I used it on a metal braided hose. I didnt really need to clamp the hose but this worked nice to cover the sharp needles on the ends of the braids.

Love this clamps but hard to come by at times and expensive

I used this small size to clamp a garden hose to the end fitting. It has held better that a worm drive clamp and 2 single ear clamps. Both of those types of clamps didn't work with the 85 psi I have coming out of my hose bibs. This Power Grip has held up without failure and I like that it is smooth and doesn't stick out like a worm clamp.

I used this to join an O.E style Norma connector to AN hose for an oil catch can - I measured twice, cut once so to speak. Nice and clean, shrunk down well and has sealed the connector to the hose.