Hireko .600 Steel Shaft Extender Silver

Bought a pair and installed on some wedges. Fit perfect and the epoxy has held up no issues.

Determine the diameter of the ping steel shaft and ordered, cut in half using pipe cutter. The extension was a perfect fit . Epoxied , let set and installed new grip. Easy process.

This project works great. I needed to extend my putter length. Worked perfect for me.

We liked everything about the product and process. Fast shipment, economical and covered the requirement for 2 golf club extensions.

I first got it and said it won't fit. It's the wrong product. Then I got out my gages, measured the diameters carefully, and realized it should fit, but it will be an EXACT fit for a 0.6" shaft. I had to debur the original shaft using a small round file and then push hard to get it started. To drive it in, I used a brass hammer. A 2x4 and steel hammer would also work. It is a TIGHT, perfectly straight, well balance fit. The most important thing to me is it is a hollow shaft so it accepts the 0.25 - 0.75 gm weights that you can add to the Super Stroke putter grips.

They fit perfectly and it was very easy! I've golfed with the new extensions at least 20 times and have had no problems.

I need to add a half inch to my 4i and this done the trick. Easy to install and regrip. Would buy again if needed.

I leveraged them shafts for a set of wedges. I am tall and was looming to extend the standard shaft by 2.5 inches. The shafts can be cur into two enabling use on two clubs. Leveraged approx to adhere the shaft extensions. Installation was easy and leveraged a pipe cutter to trip the shafts to the appropriate length. ha no issues install the new grips. Clubs swing well - you would never know the extensions were applied.