undefined

Which skin type is it good for? ✔ Normal ✔ Oily ✔ Combination ✔ Dry ✔ Sensitive What it is: A sweat-resistant, translucent formula that smooths skin’s appearance and reduces shine. Solutions for: - Dullness and uneven texture - fine lines and s - Oiliness If you want to know more… This refill for Invincible Setting Powder SPF 45 is a 100 percent mineral, sweat-resistant formula perfect for reapplying broad spectrum UV protection throughout the day. It sets your makeup and reduces shine, while smoothing the look of skin texture by diminishing the appearance of pores for a soft-focus, matte finish. Use it again and again: the ultra-soft, luxurious brush (sold separately) is washable and detaches easily from a refillable base. What else you need to know: This product is cruelty-free, and does not contain synthetic fragrance or oxybenzone. All Supergoop! products have been clinically tested and determined to deliver broad spectrum UVA and UVB protection. Clean at Sephora Clean at Sephora is formulated without a list of over 50 ingredients, including sules (SLS and SLES), parabens, phthalates, and more. For the full list, check out the Ingredients tab. * Suggested Usage: To refill: -Unscrew the jar at the bottom of the brush (sold separately) and load the refill by screwing on until tight. To apply powder: -Gently tap brush against your wrist three times in order to dispense the proper a of powder. -Apply liberally and evenly to face before sun exposure. -Reapply after 40 minutes of swimming or sweating, and immediately after towel-drying, at least every two hours. To clean the brush head: -Pull the brush from the magnetic base and wash with mild soap and lukewarm water. Tips: -After opening, remove and did the plastic pin at the center of the brush. -Tilt and tap the brush gently against your wrist until you see the powder start to flow through the bristles. -When your makeup is ready to go, brush the powder generously over your face to set the look and mattify your skin. Precautions: -For external use only. -Do not use on damaged or broken skin. -Stop use and ask a doctor if occurs. -When using this product keep out of eyes. In case of eye contact, rinse with water to remove. -Keep out of reach of children. -If swallowed, get medical help or contact a poison control center right away. -For use on children under six months, ask a doctor. -Protect the product in this container from excessive heat and direct sun. Ingredients * -Zinc Oxide 24.5%: Delivers broad spectrum sun protection. Calcium Aluminum Borosilicate, Silica, Polymethyl Methacrylate, Ethylhexylglycerin, Triethoxycaprylysilane, Nylon-6/12, Sodium Dehydroacetate, Olive Glycerides, Ascorbyl Palmitate, Ceramide 3. May Contain (+/-): Iron Oxides (Ci 77492, 77491, 77499), Titanium Dioxide (Ci 77891). Clean at Sephora products are formulated without: Sules—SLS + SLES, Parabens, Formaldehydes, Formaldehyde-releasing agents, Phthalates, Mineral Oil, Retinyl Palmitate, Oxybenzone, Coal Tar, Hydroquinone, Triclosan, Triclocarban, Undisclosed synthetic fragrances (Products can be formulated with disclosed synthetic fragrances that meet the following two criteria: (1) the synthetic fragrances do not include any of the ingredients listed in numbers 1 through 12 above and (2) the synthetic fragrances are at a concentration below 1% of the total formula) The following type of acrylates: (ethyl acrylate, ethyl methacrylate, methyl methacrylate, butyl methacrylate, hydroxypropyl methacrylate, tetrahydrofurfuryl methacrylate, trimethylolpropane trimethacrylate , aluminum salts), Animal Oils/Musks/s, Benzophenone + Related Compounds, Butoxyethanol, Carbon Black, Lead/Lead Acetate, Methyl Cellosolve + Methoxyethanol, Methylchloroisothiazolinone & Methylisothiazolinone, Mercury + Mercury Compounds (Thimerisol), Insoluble Plastic Microbeads (This prohibited ingredient applies to products that are meant to be rinsed off ), Resorcinol, Talc (Talc that is free of any asbestos can be used in the formulation provided that Brand conducts testing to ensure that talc is free of any asbestos.), Toluene, Butylated hydroxyanisole (BHA), Butylated hydroxytoluene (BHT) that is 0.1% or more of total formula, Ethanolamines DEA/TEA/MEA/ETA, Nanoparticles as defined by the European Commission ( http://ec.europa.eu/growth/sectors/cosmetics/products/nanomaterials_en ), Petrolatum and Parrafin that is not USP grade, Phenoxyethanol that is 1% or more of total formulation, Polyacrylamide & Acrylamide, The following types of Styrene (Bromostyrene, Deastyrene/acrylates/dvbcopolymer, sodium styrene/divinylbenzene copolymer, styrene oxide, styrene), 1,4 Dioxane in final formulas must comply with the thresholds as follows: (10 or < ppm for products that are meant to be rinsed off, wiped off or removed, 3ppm or < for products that are meant to remain on the skin).