MIQU 800x1400mm 180° Pivot Bath Screens Shower Screen 6 mm Easy Clean Glass Panel Shower Door (Without Towel Rail)

Really good quality shower screen, although the instructions were sketchy, it went in really well, looks good and is really easy to clean. This replaced an old one which had seen better days, along with the tiles. Would recommend this screen, but be aware that the instructions are meant for someone who really knows what they are doing.

Used to replace broken screen. Easy to install and looks good.

Well made, looks good, so easy to fit and great value for money

My joiner thought that it was quite difficult to put together.Had to use some of his own screws as what we’re supplied he did not think they would be strong enough.

This shower screen is great value for money, easy to fit, easy enough to clean.Clean modern lines and has an automatic position it rotates back to when you’ve opened the door it automatically swings back into position. Very pleased with this screen.

I drilled a couple more holes in the wall fitment. It came with 3 but I'm an untrusting type, so drilled a couple more.The wall fitment is an extruded channel, which receives an extruded bar.You fit the glass to the bar, then fit the bar into the channel and use three screws driven in sideways to lock it into place. Remember to put your plug in if you don't want to lose the screws. Learn from my mistake.My only criticism of the supplied screws is that they are not self-tappers. They are hard to drive into the aluminium bar. But I got there.I screwed in the bottom screw, then chocked the end of the glass and used a guage to assess whether it was level with the top of the bath, and adjusted the wedge until it was bang on. Then I drove in the middle screw (the top screw hole was obscured by the shower unit) then drilled a very small hole to accept the top screw.There is a very small amount of leakage under the bar, where it rests in the slotted channel. I am going to lift the glass and put a bead of silicone under the bar, that should do the trick.There are seals everywhere on the unit, generally speaking I would say it has been well designed. It hinges very nicely. The supplied seal makes good contact with the bath. If only the underside of the bar was properly sealed - or the instructions told you to use sealant, it would be perfect.Edit: I have just lifted the glass and squeezed a load of sealant under the bar where it rests on the bath, so that should prevent any water slipping under there. I then used one of those silicone flexi tools you can get for smoothing sealant, to remove some of the over-splooge that came out when I reseated the bar into the slot. Nice clean job, you would not know the sealant was even there.I have also trimmed some of the plastic mount from the end of the under-glass seal, such that the soft rubber now meets the hinge properly. It was cut off straight, I have removed about 4mm from the hard plastic bit at the top.

Easy to install, good quality

Looks great. Modern and doesn't stick to your wet body when your trying to Shower.