ECOELER 6" Dimmable LED Disk Light, 16.5W 1000Lm 3000K Warm White, Low Profile Flush Mount Recessed Retrofit Ceiling Lights Fixture for Home Improved, ETL Listed, 4 Pack

The lights are very easy to install. Comes with multiple ways of installation. I only had to use the 3 wires which the house had and connect. Plug-in play.Looks good and are very bright.

These surface-mounting fixtures work and look like recessed-lighting down floods without needing a "can" in the ceiling. I used them to add down lights in a lanai area, where they are installed on regular 4-inch round ceiling boxes. Build quality is very good, the light is bright, and installation is easy. Cannot say how long they may last. Recommended.

So far they look good , have them on for a week and rooms are fully bright and the 5000k are bright white, not warm ! installed 4 in our bedroom and they lit up very evenly.

These are economical and work great. There are three option for the motion detector on/off. I really only want them on when I’m outside but that selection only allows for a 30 second on between motions so I wish it was more like 3 minutes.

These replaced my fan lights and I’m absolutely in love with them. The price was great and they were easy to put in. They look great and am very pleased especially for the price.

These provide a nice white light for whatever space you're trying to light up. Good price for these, and because they're LED, they don't consume a lot of electricity. For a work bench, I would put two closely over top of it, though, for extra light there, in addition to lighting the rest of the space.

I really like these! I have used one so far to replace an EcoSmart LED in my new home that only lasted 2 years. These were installed in the standard deep 6-inch cans that were made to hold old-school incandescent bulbs.My only gripe is a very minor one. The instructions are very good, and pretty well written, but steps 4,5 and 6 where the "chicken feet" (the stiff wires that hold the light up flush with the ceiling when using a recessed can) really needed a close-up picture and some additional text.The problem is that there are 2 sets of keyed slots on each side. The instructions tell you to peel off the two plastic stickers (a GREAT IDEA, by the way--nicely done) on each side that reveal these two slots. You are then told to place the "spring holds" into these rectangular slots and twist them at a right angle to lock them in place. HUH? How in the world can I do that??After a few minutes of staring at things, I finally got a clue that the spring holds (the flat metal feet that hold the chicken feet springs) had a threaded hole in them. I grabbed the two shorter screws that were supplied and threaded them into the hole on each foot. Then I slid the foot with the screw into the keyed slot that was previously marked for 4-inch diameter cans (I'm installing this into a 6-inch can) and tightened the screw down. Viola! That made sense--at least to me.I've included some photos showing the parts supplied as well as how I attached the feet with the screws. I hope this helps someone else. I don't know if this is correct, but it's working for me, and the springs line up just as they should.Very nice lights, with lots of output! I got the 3000K color temperature that matches my others. It's less recessed inside the can than the EcoSmarts I have, which actually gives it a wider circle of light. A bonus.

Very easy to mount. I replaced all of my “boob” light fixtures with these.