NuNus 3D Printer ABS Filament 1,75mm 1KG Spool (yellow) for MakerBot RepRap MakerGear Ultimaker

Not bad filament.Gets too hot at 260c and prints straggly.prints best at 230-240c if u can control tempFilament layering prints best at 0.2mmThe two pictures are 0.4mm and printed quick with bubbly texture and got too hot and sagged easily.Overall 3.0 because filament colour is good but the filament heating is an issue.Printed on an up3d printer

This was ordered up Prime and took 4 days to be delivered and after a few days of using it found that the filament was very brittle and started to break which is very unusual for ABS suggest this is either been miss labelled PLA or very old stock. I don't normally make bad reviews but had to with this one.

I've tried a few different brands of filament but this is the best for my Flashforge printer. Loaded with this I get great prints regardless of colour, unlike others that require re-calibrating for different colours.

This abs seems to stick to my printer bed, could be that it not made for my printer. This material is benter for larger prints, not recommended for small quick prints. I was using a up 3d mini printer.

i have had some good long prints from this however its not pure ABS, it does not dissolve in acetone it just melts into goop but stays separate from the acetone, proper ABS would dissolve so i probably wont buy again

A very difficult filament to work with, it has a tendency to snap half-way through a print, not a very acceptable outcome cost-wise.

Thanks

Prompt delivery. As described. Good price.