AnXin 22mm 7/8” Handlebar Hand Guards Handguards Universal for YZ125 YZ250 YZ250F YZ450F WR250F WR450F TW200 XT250 TTR125 TTR230 Dirt Pit Bike ATV Quad Enduro Motocross Blue

Why the title includes crf50?Take it down now!This item is twice the length it's should be.Look at the pic and decides for yourself.

Fits my crf 125f perfectly. Did not come with directions though. But they are very strong and great color!**UpdateI wrecked pretty hard and my handlebars slammed the ground. Nothing broke no damage! Great product!

I installed these on my 2020 RPS Hawk 250 dual sport. The color match is as good as it gets. I can’t specifically attest to their strength since I have not dropped my bike since I put them on, but while installing them they seemed very substantial. A great value in my opinion.

The description is clear that these are for smaller bikes and I bought them for my son's 110, but during install, I needed to do some "tweaking" to make them fit better and they bent with moderate effort in a vice. Hopefully they'll serve their purpose on my son's lighter bike.For contrast, I installed Tusk (Rocky Mountain ATV brand) wraparounds on my 450 and I've dumped that thing a few times and didn't even scratch the finish. I also needed to tweak those, but required a torch to help.I think these are a good value considering the price, but I don't think I'd trust them on any bike over 150lbs.

work as good as bark busters Not too hard to install & does the job but make sure when installing on throttle side the holes big enough so you don't Make your throttle stick like I did... worth every penny!

I purchased these after I purchased a set of the JFG versions which are identical. I'd say the hardware on this kit is much better than the JFG. I've gone down twice already on both sides and the hand guards held up well. Buy these and not the JFG version. IMO

If your looking for cheap hand guards then these are the hand guards for you. The hand guards are pretty good but the mounting hardware is not... ordered these just for the mounting hardware while I waited on some Tusk guards to come in. I rode and hit a couple to objects with the guards and when I replaced the guards with the Tusk ones the bar end bolts were already bent and could not be used again. In my opinion if you need some good guards spend $30 more on some Tusk guards.

Absolutely garbage produce. Save your money and buy a name brand instead. They bent after the first tip over of a KLX140. After just a couple drops they were bent beyond use. The hardware is as soft at putty and the hex bolts strip out on first install.