Spare Tire License Plate Frame with LED Light Compatible with 1987-2018 Jeep Wrangler JK JKU & TJ & YJ, Licence Bracket Holder Rear Plates Frames Relocation Mounting (2/4 Door, Black)

Jeep

Seems like a good, solid bracket. Will see how it holds up over time. Wiring is simple.

The bracket and light work fine and look good, but be aware that you will have to trim the tubing to length if you don't want your plate sticking way out past the tire.After reading some reviews about the flimsy welds for the nuts used to secure the bracket I drilled a 1/4" hole all the way through both tubes and used a pin and hitch pin to hold it. More secure, and doesn't require tools to remove.

Fits good. Now to hook up light

It depends the rims you have to cut it or do the holes bigers. I did both and work great. The light is to much stress take it out if I need replace the tire so I didn’t connect it…

These welds are terrible. The day that this was mounted it broke off leaving my license plate and backup camera who knows where. Looking at the mounting plate that the bracket welds to you can tell that 3 of the 4 welds had zero penetration, and the paint was mostly what held this thing together. I retraced my route wasting about $45 worth of gas, but no luck. Now I have to replace my plate, replace my camera, and buy a better quality bracket. Definitely upset I didn’t buy better quality to begin with.

Well built and easy to install. Light is clear, bright and simple to wire.

Update. My original review stated the holes did not match up. With no instructions, I lined up the holes and originally they did not fit. The next day I tried again and flipped the base upside down and those holes matched. It was not apparent the spacing was any different. Some indication on which side is the top and bottom would improve the product. I have not yet wired the light, so tbd on that process.I would say overall the product is ok. The bar is not perfectly straight but it's probably not noticeable on the road.