All Stainless Steel Keg Coupler Low Profile, Sankey D System Coupler Space Saving Keg Tap Dispenser kegerator Parts with Pressure Relief Valve,1/4''Beer Barb Out & 3/8''Gas Barb In & Hose Clamp

Taps effortlessly with no mess. Very compact, with no troublesome washers to replace

Changed out barbed fittings for ball lock fittings (https://smile.amazon.com/dp/B08JV437QV?psc=1&ref=ppx_yo2ov_dt_b_product_details).

I have yet to use the product but from a strict aesthetic point:The good: Size wise this coupler is perfect, I’m building a kegerator from a mini fridge and this allows me plenty of clearance.The bad: Both barbs are the wrong size. The beer hose coming off my tower is 3/16 ID, which after doing research is the optimal size, but this coupler comes with 1/4 barb. On the CO2 side the inner diameter doesn’t matter as much but most all the CO2 line I’ve found is 5/16 ID but the coupler comes with a 3/8 barb. I don’t know why this is but you could just run the tubing under hot water for a little bit and jam the fittings on, but I’d rather just use the correct size fittings.I have purchased the correct size barb for each side(pictured above).*Replacing these is easy, use a 9/16 wrench or adjustable crescent wrench. Clear off any leftover tape from the interior threads of the coupler. When adding the new barbs, wrap the thread in a pfte plumbing tape opposite of the direction you will be screwing them in.Get approximately 3-4 wraps around the threads. After they’re taped up install them, use the wrench to make sure they’re good and snug.Will update the review after using the product

No problem install. Now kegs fit in kegerator

I needed to add a second tap to my kegerator. The coupler that came with it was a Kegco low profile. I couldn't find another one like that so I ordered this instead.Took off a star because it came without a manual and the box was banged up. I didn't need a manual, but if you were new to this you might not know that the CO2 barb is the one adjacent to the relief valve, and you may not know that you have to turn the coupler to the stop, then PUSH DOWN to engage the keg valve, and then turn the coupler a bit more until the 2nd stop.

WOW! I ordered this item less than 24hours ago and it arrived at noon today. Awesome Prime! And it's a perfect fit for my keezer.

Worked good for about 2 years. Noticed beer starting to be more foamy lately. Checked the coupler and saw green corrosion forming on each tube fitting.

Prior to switching out to this coupler, I was using a 1/5 Barrel tilted on edge in my converted commercial under counter refrigerator (Kegarator) , and can now accommodate a 1/2 Keg standing up straight. More beer and easier to work with! Thanks

With the traditional coupler I had to tilt my keg in the kegerator. Now there is enough clearance so I can stand it upright and have the lid close properly.