QA17888109 Thrust Washer Mount Kit

Bought a pair of these for my BC Racing coilovers. Front of my car has McPherson struts, and with the coilovers in the oe configuration and set to the recommended specs I was getting some nasty spring bind when I turned the wheel. *Ping ping ping ping*. Put these thrust washers on the bottom perches, lubed them up with a little grease, ignored the recommended preload and just elimi ated any slop, covered things up with some "coilover socks" and I've been good to go for quite a while now. No more spring bind. Highly recommend these if you are having similar issues.

Had these on my coilovers for about a week before the right side started to bind again I checked and the bearings are literally falling out. The left side is perfect and no noise. Not sure if this is just a bad batch. I do recommend these (the broken one still binds but it’s 95% better than without it) just be aware that they may not support the weight of your car.

Bought these to use with my new qa1 coilovers on my 69 goat. They work great and make adjustments much easier. If your using coilovers get a set you will be glad u did!

One of the washer bearings arrived separated, with missing bearings. Now, I’m waiting another two days for a replacement so I can reassemble my shocks. Not happy.

It works as advertised, but unfortunately they are made from steel that can rust. Only the center piece with roller bearings is made from stainless steel. I would not recommend using this on a car that drives through rain/snow/salted road. You will be better of with Swift thrust sheets.

This was perfect for using at the bottom perch of the Ohlins coilovers. Allows the spring to turn freely and not bind under load.

I can't wait to install these thanks so much for the speedy delivery

Product was exactly as described. Used this on my coilover shock on my 67 camaro.