Loboo Idea11 Pieces Damaged Screw Extractor Set, Remove Broken Head Screw & Bolt Screw Extractor Drill Bit Set, Adjustable Tap Die Wrench Stud Remover Screw Extractor Set (11 Pieces Screw Extractor)

Disappointed it didn’t work, however the drill bits do and I’m keeping it for those. Ultimately I had to cut a giant hole to get the screw removed from the wall. Maybe they will work on a different screw another time.

recently had installed front deck floor had several stripped screws heads. used designated drill for screw and used easy out to remove and replace screws

I got this to try to remove a broken antenna base that was snapped off in the car wash. None of the bits were able to penetrate the antenna, and the smaller bits broke with very little force. This product may do fine on some screws, but not on anything durable.

Fixing the waist and overflow on my bathtub

The wrench and two extractors broke the first time they were used. Not only did they not accomplish the job, but the broken extractors made it much more difficult. Would not buy again.

Half the drill bits broke will not buy this item again

It might work ,, but it you have a very sticky bolt,, it will not.

Got my broken screw kit today and it is missing the 2mm drill which happens to be the size I needed and the reason I bought this item. Several of the bird and drills were loose in the kit box and the 2 mm drill was missing.

Terrible set, drill bits might just about get through a block of cheese. The extractors shatter under the slightest pressure, snapping in the bolt/screw you trying to extract, £18.99 wasted. The clamp also snapped into about eight pieces. Should of believed the overwhelming majority of reviews. In the end I used one of my own drill bits, hammered an old screwdriver in and put mole grips on it.

Very poor quality, each drill bit only stayed sharp for one drill hole and then the stud extractor snapped before the stud was released. I only have the 2 largest left which have not been used but I’m not holding much hope going on the smallest 3 bits.

After drilling into the bolt I tried the appropriate size extractor from the kit and....it actually made the situation worse by snapping inside the drilled hole. I did not use excessive force, the snap came easier than opening can of pepsi. Don't buy this kit.

Drill bits were no way near sharp enough to drill into the metal stud. Had to use a bit from my own stock. The extractor bit then sheered off as I tightened it (by hand) making the problem 10 times worse. Waste of money.

I was sceptical as to how well these would work, but needed to remove sheared bolts from aluminium engine block. You need to make sure the centre hole really is drilled in the centre of the stud, and give the remover a bit of a tap with a hammer to get initial purchase, but then they did the trick. Bolts removed with no thread damage! Brilliant.