Specification:Condition: 100% brand newProject Type: Injection Molding SetMaterial: MetalLength: about 136.5 mm / 5.4 inchesDiameter: approx 27 mm / 1.06 inchesPackage weight: about 668 gramsUsage:1. Remove the instrument and place it on the table.2. Place the injection pen in the pressurizer.3. Push the pusher down to the end and pressurize.4. Remove the switch head and syringe from the sterile bag.5. Connect the switch head to the syringe and screw the reinforcement to the right.6. Place the switch head into the bottle and use the piston to draw the desired dose.7. Adjust the corresponding instrument line with the pen.8. Tighten the syringe clockwise in the pen.9. If there is a bubble in the syringe, tap it with your finger to raise the bubble to the top.10. Remove the instrument vertically and rotate the bottom of the instrument to the right to capture the gap and air until the water droplets are on the syringe.Package Included:1 x injection pen1 supercharger1 syringe1 conversion headNote:1. The dosage applied to each point of the skin is 0.05~0.08 ml, different parts of different doses. The dot pitch is 1 cm.2. Do not use too far when using it, be careful when using it.
Trustpilot
2 months ago
2 days ago
