Replacement Spring for Pruning Shears, Precision Trimming Scissors Part for Heavy Duty Bypass Pruner, 2 inch

My clippers/pruner were left by the previous owners of my house and had no brand name anywhere on them. If you have the same dilemma, remember to measure the outside dimensions where the ends of the springs go, as well as the distance between them with the clippers fully open. Then, add about 3/4ths of an inch more to that length so that the clippers spring open properly, but are not too tight to close. And, the diameter of the ends of the spring should be about 1/16th of an inch smaller than the diameter of the opening so that they are still snug but easy to insert. (If there is a little post inside the opening, the spring diameter should also be about 1/16" Bigger than the post.) Glad that it is a pack of 2 so that I have a backup the next time the spring gets caught on a branch and flies deep into the middle of a bush, never to be seen again!

Perfect replacement item.

Refurbished old pruner, the spring fit perfectly.

YMMV, but this restored the spring operation on my Corona bypass snips.

Cannot compress spring enough to close Fiskars Softgrip. Looks like a good spring if you can use it.

Great quality product that worked well, and easy to install, gave new life to my garden pruners.

Snipped off two coils and it fit perfectly well in the Tabor Tools pruning shears. And this one will almost certainly not fall out on its own.

These springs fit my pruning shears perfectly and provide the right amount of force. They will probably fit most pruners but check the dimensions.