TRQ Front CV Axle Shaft Assembly Set Compatible with 2011-2017 Lexus CT200h 2010-2015 Toyota Prius 2012-2015 Prius Plug-In

The part is made with good quality materials and the price was reasonable. It was also the right fit for my 2007 H3 Hummer

Fit perfectly in my 2013 Hyundai Sonata Limited. Installed 3 weeks ago and clicking is gone when turning. Watched YouTube video and was easy install.

Good quality. Fair price

The TRQ cv axles are not holding up at all on my 09 2Wd Acadia. The boots on both axles are severely cracked and leaking grease with less then 2 years of installation. Both axles pop when going from drive to reverse and the front right is causing a slight vibration over 60mph since new. They are supposed to be lifetime warranty but when you call the customer service phone number there is a recording that directs you to email them and no way to speak with anyone. I would not recommend this product or company due to inferior quality and not being able to speak directly with customer service. I have emailed TRQ and am waiting for a response.

Fit perfectly. Wasn't that hard to replace either on my 2015 Ford Escape

I don't know what I purchased last time or if I got whatever the warranty purchased at the time. But these looked great and worked great. I try to use all there parts on my other vehicle! They are way better made, live the price and a great replacement choice. Very easy to install if you're handy.

The installation of the axles went as smoothly as could be hoped. I was concerned about the removal of the snap ring that holds the bearing in the support on the passenger side, but it came right out. The passenger side replacement was trivial. The drivers side was a bit more difficult since I didn’t have a slide hammer. I pried the old axle out with a pickle fork, probably not the best method, but it worked. Installing the new axle was exactly as it should be. Aimed clip ring down, slid it in with a slight jiggle to line up the splines. A couple raps with a dead blow hammer, job done. I read one review where they pulled the joint apart. DON’T pull on the end of a CV axle for any reason. The only thing you will accomplish is an education on rebuilding them.The axle looks a little different, but is identical where it matters. The hub nut is a 30 mm 12 point, where my original was a 32mm 6 point. Nearly all my sockets are 6 point, so I had to spend 10 bucks on the appropriate socket. That’s the only complaint I had. Everything else was as good as it gets.

Purchased for a 2001 gmc yukon. Installation was smooth. Replaced cv axle at the same time we replaced bad wheel bearing/hub assemblies. Both sides are now finished. New axles run smooth and quiet too. Cv axles came with required parts/nuts.Recommended axles!!

Front axle AWD with ABS wheel