POWERTEC6 Inch Jointer Blades for Delta 37-190 37-195 37-205 37-220 37-275X Jointer, Replacement for 37-658 Jointer Knives, Set of 3 (148031)

Bought these to restore an old Summit 6" jointer and they work perfectly. They came well wrapped and after pulling them out I checked them for true. They were all perfectly straight and very sharp with a clean grind on them. After getting them installed and adjusted, they did a fantastic job on test pieces of both soft and hardwood.

Blades were the exact dimensions in the description and were a good fit for my Powermatic Model 50 Jointer.- Checked against a known good straight edge and the blades were dead on.- Blades were razor sharpI don’t know how long these will retain their edge compared to other options but for the price they will work nicely until I can afford a helical cutter head.

Haven't installed these yet but they were shipped well packaged and are sharp should work well on my old jointer.

They where a bit to expensive and exactly 1/8 th shorter than my old ones but they worked anyway,I haven't used them but on one short board.but they seem sharp so far.

The blades were purchased for a 1950 Delta 37-205 jointer. Arrived very sharp and packed together in a single plastic sack inside a reusable sliding plastic espresso-color container. Some reviews mention a compound bevel, yet both sets I received were single. The blades were identified in the middle with the Powertec logo.The original Rockwell blades were 0.093" thick and the Powertec are 0.117" which is few thousands shy of 3mm. The knife lock bar bolts had 0.08" additional adjustment which is enough to accommodate the new blades.The Powertec blades are 1/16" shorter than the 6 1/8" Rockwell. The Powertec are right-angle ends so do not have the 2-degree rabbit relief on the right end of the blade. Width measured 0.680" which is close to the stated 11/16". Fractions are not acceptable for this part. Especially for the thickness. Typical tolerancing for fractions is +/- 1/32. That is why decimal is more appropriate.The rating of HIGH SPEED STEEL is also not good enough. There are many ASTM ratings for HIGH SPEED STEEL which is not published for these blades. It's a direct comparison to not publishing a durometer rating for rubber or plastic. You do not know what you will receive. It's impossible to know Longevity which is one of the star-ratings when doing a review esp. when blades have not been installed. Most people's Longevity rating is very subjective.

Although they say 5/8" they were 1/32" over and had to be ground down. Couldn't find knives with a rabbeting edge but seldom use that feature on my jointer. Seam sharp enough initially, time and material will tell.

Great timely shipping

Good product, they cut good and smooth.

It’s a bit tricky and dangerous to remove and replace jointer knives. If you are at all concerned about the switch out you should get help from a professional or buy a new jointer that fits your tool. Don’t risk your hands or eyes! Get help if you have any concerns!

Si llegaron con buen filo y se miraban bien, y no se si son así, oh! me tocó mala suerte, pero solo endereze 10 reglas de madera de pino de 3/4 x 10 cm x 2.50 mts de largo y se les terminó el filo, no sé amellaron ni nada por el estilo, simplemente se les terminó el filo por eso les pongo ⭐⭐

Work great and did not use the other set

Good

These blades came sharp and were exactly the right fit for our Beaver Planer/jointer