GBJ APMT1604 PDER APMT160408PDER APMT1135PDER Milling Inserts Turning Inserts Cutting Tools for BAP400R Milling Inserts Tool Holders Processing Hard Steel Parts (APMT1604 PDER)

fit our tooling on hand and handled the d2 like a champ will order another pack or two.

Chews through 6061 like butter, mirror finish. Can't beat these for the price.

I use these inserts in both a 2" and a 3" face mill, frequently on 304 stainless. Surface finish is great and they hold up pretty well. They have 2 cutting edges per insert. They are inexpensive so I I feel I am saving money and don't mind changing them out when they get a little dull. BTW, awesome on aluminum, and heavy cuts are no problem in a Bridgeport.

Meets expectations.

Originally these had no lifespan, but then I lowered the tip speed, they perform very well now.

Honestly wasn’t expecting much out of these but they’ve chewed through CR and HR plate without any issues. Even ran some Ti with them and they did the job. Obviously there’s better stuff out there but for a cheap insert they hold up awesome

picture shows 20 inserts... the order says price is for 10 inserts.... a bit of a little trick....

These inserts swill eat their way through aluminum like nothing else. I put them in a 2” diameter face mill. With a spindle rpm of 4000, a depth of cut of .300”, width of cut set at 1.75” and chip load of .015 per tooth. The chips fly off like a rooster tail. I have only used this on an enclosed machine.

With these I get a mirror finish on both steel and aluminium.

Maquinado en acero duro.

Deja un muy buen acabado en espejo

cutting aluminum they work very well nice sharp square corners