9XR Standard Features: • 8 Channel PPM/9 Channel PCM • Full Ball Bearing gimbals • Adjustable Stick Length • Digital Trims on all Primary Axis • 16 Model Memory • Assignable Switches • Freely Assignable Channel Mixes • Graphical Dual Rate and Exponential • Sub Trim and Travel Adjust • Flaps and Differential • Throttle Hold • Supports Heli/ Aero/ Glider Model Types • Programming Templates Based on Model Type • Supports M1, M2, M3, M4 stick modes • 128 x 64 backlit Liquid Crystal Display • Built in JR & Futaba Trainer Ports • PPM & PCM Output • JR Form Factor RF Modules (Orx Dsm2, Orx Open LRS 433Mhz etc) • Programmable Timers • Low Voltage Warning and Buzzer • Supports 3s Lipo (Required) • 9XR Firmware Pre-loaded • AVR ISP Interface • Internal 2.4GHz Antenna
B**Y
Good radio for the money, highly recommended
I love this radio. The fact that you can use modules means I can fly most of the RTF or BNF models I want to buy with the same radio, which is great practice for the larger more expensive models.I have configured the radio for both MultiWII and APM flight controllers and was able to get all the features enabled and working exactly how I wanted.I have not had any problems with this radio except that you must hold the throttle all the way down to avoid the "your throttle is not idle" warning on power up. Simply moving the stick to the bottom is not enough, I must exert force onto it to pass this warning. This is a minor annoyance.
R**N
Two Stars
Over priced!
A**R
Amazing with OpenTX software
3/6/2016I felt I had to write a review for this amazing radio that I've been using for two years. I recently installed open TX 2.17 firmware on this device and the results could not be more outstanding. I bought this thing for about $50 an extra 20 for the djt frsky module and it has been nothing short of fantastic. To program it I used a usbasp device with the main.hex firmware.
Trustpilot
1 month ago
2 days ago
