🔋 Power Your Potential with Confidence!
The 24V 4A/5V1A Dual Switch Power Supply Board Module is a high-performance, isolated dual output power supply designed for industrial control systems. With a voltage input range of AC 90-265V and a total output power of 120W, this module ensures reliability and safety with multiple protection features, all housed in a compact design.
W**I
Works as a replacement internal power supply for the Klipsch Cinema Soundbar 600
Works great, I honestly thought the soundbar was dead for sure, but after removing the back plate (which was a task in and of itself) I finally replaced the board and re routed the wires like @David Ying and @R. Bear mentioned. Thank you guys! Works like brand new.
G**R
YAY, my Klipsch Cinema Soundbar 600 lives again.
Works great. Thanks for everyone's guidance.
E**D
Worked great to repair my Klipsch Cinema 600!
My Cinema 600 had a dead power supply as others have stated. Easy to install just making sure to properly connect the 24v/5v and ground connections. It's somewhat shorter than the original so I drilled another hole in back of soundbar to utilize the original bracket and screw. There are forums online if wanting to use this power supply for this purpose.So far has been working fine for a few weeks and hoping it lasts as long or longer than the original.
R**R
Inexpensive repair for Klipsch 600 Soundbar
I bought this to do a diy repair on a Klipsch 600 soundbar that would not power on. This part wasn't quite the same size as the existing part, so I had to drill a small hole in the back of the soundbar panel so I could screw into the l-bracket I transferred from the old part. That way, the left side of the new (smaller) card was held up by the slot in the soundbar back panel, and the right side is held up only by the l-bracket and screw. Also had to remove the connectors on all the wires from the old part and hard-wire them in on the new part's connectors, but this was fairly straightforward. From another post somewhere I learned that on the 5V side, the black and red wires from the soundbar need to be connected to the (+) side, and the white goes to the (-) side. If you're somewhat handy with diy, this is an inexpensive repair and takes about an hour. Soundbar is working perfectly now.
M**N
D.O.A
Straight out the box, applied 115V AC and got nothing on DC output. No 24v or 5v.
D**G
Great fix for Klipsch Cinema 600
Had the common power failure issue with the Cinema 600 and thought it was broken. Took some googling but used this to fix the issue in around an hour. I’m not an electrical engineer either but this is an easy DIY for anyone.There are two versions of the wiring in the Cinema 600 out there - if you have this one, follow the image attached and it will power on! Magical and working great once again! Hope this helps someone out there.
C**X
50/50 THAT IT WILL WORK NEW OUT OF THE BOX
It did the job but took 2 tries to get one that works.
R**O
This worked on my klipsch soundbar 48
My soundbar 48 had just died. No power what so ever. I looked around and I guess the power supply klipsch uses in that soundbar is known to fail. If you have a little dyi in you this wasn't too bad to put in. There is some posts on redit that helped.Shipping only took a few weeks maybe less in my case.
T**T
Allerbestens!
Hat super geklappt. Auf Wunsch sende ich gerne bzgl. Kabelanschlüssen noch ein Foto!
Trustpilot
5 days ago
1 week ago