Power StopJBR923XPR Front Evolution Drilled & Slotted Rotor Pair For Acura CL, Acura MDX, Acura TL, Acura TSX, Honda Accord, Honda Odyssey, Honda Pilot [Model Specific]

So I have been running these Power Stop drilled/slotted rotors for a while. In fact, the first purchase I made was 6 years ago. In that initial purchase, I bought the complete set front/rear rotors. I even put the full set on my wife's Subaru and they haven't had any issues for 5 years. The ones on my car (07 Acura TL) have been through the paces, and finally in year 6 the fronts started to develop a warp. The rears are still holding up fine. You can see in the one photo, the old one compared to the new one. I have been happy with the rotors they do just fine. The biggest thing is that you need to bed in the pads properly to the rotors and they will last you a good while. Not to mention they look great behind an open wheel design like the mesh wheels I have.

Slotted rotors don't do well if they're just moderate quality like these, once they warp, even a little you'll get noise due to the uneven surface, these rotors didn't last any longer than standard rotors.I bought rears as well and same issue, including noise from rust from the slots. As you know rust causes expansion, so the slot was filled with rust which caused noise at around 80km.

Installed these on a 2005 Acura MDX. No problems with fitment in place of the OEM units. Paired with Power Stop Extreme pads, they are providing firm, quiet performance so far (+1500 miles).

This is my wife's second set of these same rotors. Second set is already getting shaky less than a year later. I even did proper breaking in of the rotors. They are just junk plain and simple

They're solid brake rotors. Haven't warped yet and I've made some hard stops to test them. On that note, my car seems to stop harder and faster now, granted that could just be because I'm more confident in my car's stopping ability with fresh, non-warped rotors installed. Either way, these get the job done for a very good price.

Used on a 2010 Accord. I have put 5k miles on these and they are smooth and increased the breaking action by 15 percent.

Installed on a 2004 TSX with no fitment issues. The brakes were initially making a squealing noise after the install. But after a few days of driving and some hard stops, noise went away and everything was good.

Came quick, have installed before but very easy. So far good braking and no squeals. Little bit more but happy with performance