Wellmate WM-6 / WM0075 QC Captive Air and Retention Fiberglass Tank, Quick Connect (19.8 gal / 75 LTR.)

Easy to install. Grease was not sent with tank for o-ring connection. Bought a tube of plumber’s grease for 3 bucks. Used plastic kitchen wrap and rubber bands to keep dirt out of connections until ready to slide together. Greased both ends and slid it together. Could not be easier.

Installation was easy. You can purchase a replacement bladder for the inside of the tank but it was 3/4 the cost of a totally new tank so I just purchased a new tank.FYI these tanks are designed to reduce the number of times your pump cycles so that you reduce wear and tear.Works well with my 1/2 horsepower well pump. It comes prepressurized with air but I had to bleed off some air as it was over 100 degrees so the ambient temperature was different. Once the tank heated up I pulled more air off the tank and was ready to go. (Follow mfg recommendations on your starting pressure for your pressure sensor.). If you check your pressure gauge and it is at zero, you probably have too much air in your tank causing the hydraulic pressure to go below 10 psi, where some pressure sensors will cut power to your pump (to keep it from burning out). Either that or your well is running dry.

My first one lasted over 20 years. Is plastic and fiberglass, so no rust. Since the measurements have stayed the same, easy to install.

Quick Service. Quality tank.

very well built