KNIPEX86 09 250 V01 Tools - Jaw Protectors For 10-Inch Pliers Wrench 86 XX 250 (8609250V01), Red

Saves me time . And saves me the trouble of risking damage to finish trim in a shower.

I used these to take off my brass shower head, they do slip a little bit since there's no teeth or anything but they seem to work good enough to get the job done. Recommended if you have the Knipex pliers wrench. Note the size is per the smaller or larger wrench. They stay on well, matter of fact takes some effort just to get them off.

They don’t mar up the chrome finish I use them for but they are ‘squishy’ and do not grip as well as if I didn’t have them on. After a few uses they start to not stay on the plier and I have lost a couple due to them not staying clipped. They’re functional enough but they do not grip as well. Would buy again.

The product is excellent, I advise you to buy it!

This is used when you want to keep things as scratch free as possible

The jaw covers/protectors are a pretty good idea, however the upper cover doesn't snap in place as depicted on my 86 03 180. The 'lock in place' feature is about .050-inch too far forward on the jaw to snap/lock in place.

I wasn't sure before I purchased, and Knipex even says they won't in a customer question above. But I took a chance anyway, and am glad I did. These popped right on to my 10" Cobras, and are pretty secure there. I have no doubt they would fit the 10" Plier Wrench even better. But if I didn't know better, I'd almost believe they were made for the Cobras. Certainly good enough for occasional use. Especially since I don't (yet!) own a Plier Wrench, these are very useful because the jaws on the Cobras, unlike the PW, have very aggressive, sharp teeth. So these protectors really transform the tool in the case of the Cobras.In fact, I found that in a pinch (no pun intended) I can even use these with my 10" Wiha sliding joint pliers (a Wiha version of the Knipex Alligators). With three sets to a pack, these are a great value.One obvious caveat: while these fit great over the jaws of the pliers, they don't have the same profile as the jaws. Unlike the Plier Wrench, the Cobra's jaws are indented, not flat. So, you'd want to be careful about gripping things from only the center with these attached. That said, the pads are surprisingly sturdy and I don't think it will be much of an issue. Handy to have and beats a towel.

Removed a stuck microscope objective (paired with the matching Knipex plier. Able to control the squeeze, objective loosened, finished with fingers.

COM CERTEZA DESEMPENHA UM BOM PAPEL, PORÉM AGENTE VÊ QUE O PAR QUE NÃO DEVE DAR PARA MUITOS USOS, É PROVÁVEL QUE POR ISSO VEM 3 PARES NA EMBALAGEM, PORTANTO USAR QDO O ACABAMENTO QUE FOR APERTAR FOR MUITO DELICADO, ATÉ PORQUE A CHAVE ALICATE DIFICILMENTE ESTRAGA ACABAMENTO CROMADO SE FOR USADO COMO SE DEVE.

Je suis un peu decu que ce soit vendu en kit melanger, j'ai seulement des 180 et ds ce kit il y a un kit pour 180, 200, 250

Produit knipex qualité assuré,bonne achat.

such a cool add-on to have available. Great for chrome finishes (motorcycle parts eg.)

Fits perfectly on my 86 01 250. This is a pack of three sets of protective covers.