G7 Power LCD Screen Replacement Touch Display Digitizer Assembly 6.2" 157mm (Black) for Motorola Moto G7 Power XT1955-5 XT1955-6 6.2 inch with Repair tools and screen protector (US Version)

I've replaced a few of these and this kit is worth it.

This was not an easy replacement. I am an automotive technician so I regularly work with my hands and tools. Watched 4 videos before attempting this screen replacement. Operation successful. Used recommended B-7000 glue to secure screen and rear cover back into shell and clamps to hold for 12 hours. Supplied torx driver did not fit internal screws, had to use old eyeglass repair kit tools. Gotta make sure that this is the correct screen for your phone, I still had the original box with the exact model numbers on it.

Terrible product! Screen blinks on and off at random. Touch screen is crap! Random stuff just comes up not sensitive at times then over sensitive at other times. Screen broke the 1 st day. While in my pocket, Waste is my money!

This Kit is very substandard if you personally attempt to repair your own Cell phone.1. The tools provided, miniature screw, torx, and flat head drivers are of the quality of kid's toys. The torx driver was not the correct size of the screws in my phone. The quality of steel of the tools was substandard.2. The adhesive strips to reassemble the phone with were of poor quality and very difficult to separate from the paper backing.3. The plastic tools; both bent and broke.As an electronic technician, I was fortunate to have my own tools and supplies to accomplish the repair.On a positive note, the Screen and backing plate did fit correctly and perform well.In closing; Do not purchase this kit with the intent to repair your own Cell Phone -

The screen works. The tools they provide not so much. The T1 drive wasn't the right size it was actually way too small. The plastic pry tool broke, basically a one time use. The screen protector would have been a nice bonus if it fit the screen.

Screen was perfect. Exact replacement. Followed YouTube video to replace the cracked screen. Only problem I encountered was the small metric star screwdriver bit was the wrong size for the screws in the phone. Luckily I had one in another kit from prior work. The adhesive provided was black instead of clear, but this wasn't a problem. There is a very small amount of the adhesive in the tube, so I suggest you apply a thin layer around the perimeter, and then go back over a second time until the tube runs out. This way you aren't left with only half the phone covered with adhesive. Good Luck!

Installed easily exactly what I needed will use this supplier again

Half inch too short. Gap at the bottom of the phone. And adhesive doesn't stick well at all!!