Thermal Pad, 100x100x0.5mm Highly Efficient 6.0 W/mK, Insulated Heat Resistant Silicone Pad for IC SSD CPU GPU Heat Sink LED Cooling

Got this for my new Onewheel controller. Hasn't hit 100F since installing it. Seemed a lot more quality product compared to the thinner stock one I was replacing. Easy to cut to fit, and work with in general.

I bought this to mount a heatsink on my GPU's backplate to aid with VRAM high temperatures.Pros:- Comes at a fraction of a price compared to reputable brands.- Easy to reapply without leaving a mess. I had to readjust the location of the strips a few times and never had trouble removing and reapplying them.- Brought VRAM temperatures down 10 deg Celsius, so it works.Cons:- I think it has higher hardness than Gelid Ultimate. Meaning, you will have hard time applying this thermal paste on uneven surface such as applying a single strip spanning multiple SMD components of various heights. In my case, the GPU backplate had a slight bulging and this thermal pad did not help at all to compensate with this. As a workaround, I cut the pad into separate strips, and try to carefully push against some to force them to make contact with both surfaces.Overall, it works very well with even surfaces. It's an affordable solution if you need a large quantity for even surfaces.If you plan to use this for a GPU backplate, remember that a heatsink with thermal pad is not enough. You need a fan as well to aid in cooling.

miner was overheating. took it apart and used this to replace the cracked thermal pads. worked very well and reduced temps significantly

Old 1070 was having thermal issue when playing BL3. Made a big thermalpad fill so the board contacted the backplate through the pad. Also replaced VRM and VRAM thermal pads along the way in the front.The thermal pad came through the mail and there was a big fold mark on the protective films, the pad sandwiched between was unaffected. There were ~1-2mm silicon chipped off near the edge probably due to shipping and handling. Both could be avoided if the pad was shipped with a cardboard inserted and used do-not-bend stickers.

Multitude of uses for my repair bench. Good quality, heat transfer, and thickness.

Great seller, good product, great price!

Used on a 3080 ventus 3x 10gb. 2mm thickness. I bought 3 by mistake and ended up with really high temps. turns out, because this pad is really firm, the thickness matters even more. So I got the 2mm, popped them on, and wham, -5c delta from stock. My pads were fine before, but I was doing a complete open, clean, painting shroud, and repaste of the card anyways. excellent value for the price. You could spend double this, and get about 7c less than these with gelid or NB, but for this price, excellent performance

Half is applied to macbook pro 2018 i9 intel. Bottom plate became very hot then mStand too. Then air cooled. Very satisfied