Kelbert-SDS Plus Floor & Wall Scraper Tool
| Manufacturer | KELBERT |
| Part Number | 20010 |
| Item Weight | 1.14 pounds |
| Package Dimensions | 11.1 x 4.76 x 1.73 inches |
| Item model number | 20010 |
| Material | 40 CR STEEL |
| Batteries Included? | No |
| Batteries Required? | No |
R**N
It's an ok product for minor projects.
This chipper floor scrapper bit is pretty ok I guess, I work construction and do a lot of demo. The one complaint would be its durability, after the third use the bults started to loosen so I have to constantly tighten them every few minutes which can be annoying. Other than that it gets the job done.
K**E
Repeat customer!
Nearly 1800sf of tile & thinset removed before the shaft failed. Successful tool in my book. Bought again to finish the job. Much better than a tile cart that did more damage to foundation then remove tile. Great product!
A**R
yes, the bolts can loosen
However they didn't causing any problems while trying to pry up vinyl tile.I'll probably change the bolts out and use lock washers for any future jobs but I'm actually hoping I never need to use this tool again!
J**J
Solid Build but Handle is to short!
The tool itself is a solid built tool, and does do good with smaller jobs. The problem is the handle is so short, your face is right next to the debris your scraping. Also make bigger jobs a back breaking experience.Maybe OK for a homeowner doing a one time job. But spend the money to get a longer handle scraper if your a contractor or doing more then one small job
J**A
Tile and thin set removal
Used to get thin set mortar off small bathroom area. Worked great for small area but would be difficult for large area.
A**N
worth it
100% necessary to remove large amounts of thinset. Made short work of the tile removal. Make sure you add some lock tite to the bolts
V**A
Not worth the money or time.
GARBAGE!....Overpriced extremely small and poorly made. Looks as if someone took an old chisel in bit drilled 3 holes and put on the square metal plate. It's not even beveled or shaped. Just a square piece of metal. I have to use it cuz the job needs to be finished now. I ordered the correct one but the wrong size bit was sent. Now I'm stuck or I would return it and try again.
K**M
A bit thinner metal than I expected
I have an 8 inch blade that is almost an 8th inch thick and will never bend, this one is about a 16th inch thick and will bound easily with pressure. Expected a little thicker and more robust metal blade
Trustpilot
2 weeks ago
1 month ago