14Pcs Pocket Hole Jig, 15 Degree Dowel Drill Joinery Kit Hole Screw Jig with 6/8/10mm Drive Adapter for Woodworking Angle Drilling Holes, Carpenters Woodwork Guides Joint Angle Carpentry Locator

Very pleased

I’m not entirely sure hot I feel about it. I used it once and didn’t like it.

If you are a novice this device will make you angry. If you have experience this device will do ok but it's not worth the effort. Spend your money on better higher quality jig. I used it on one project drill 7 holes and number 8 not only did drill bit break but thr jig actually had warped. Mind you ibwas make a frame and I sanded each piece after drilling pilot holes and making sure angles lined up.

Muy útil

Seemed OK for the money but I tried seating the collars and they were tight, new product and paint, so I put some WD-40 and slowly worked the collet into the threads and backed out working them slow and easy until they would seat correctly. The first one seated, the second one 3 threads form seating twisted apart at the threads. The smaller colleta fit just fine but it was the largest that broke. I was really bumbed out as it was my first time using pocket screws for some dog-legged shelfs. I would rather a steel jig for a strength.

The drill bit broke the first time I used it. Threw it away and went a different route

The bits are nice along with the stops but the the tool isn't long enough and it let the drill bit wants to move everywhere and the holes are not straight

This jig is the reason I decided to stop being cheap and buy a quality pocket hole jig. It’s very difficult to place, and not very accurate. It is made of decent aluminum, but the design is flawed. You will not be satisfied with this product.

Product is good but I never received the clamp.

Petite erreur dans l emballage, ils m ont envoyé un autre kit complet. Que demander de plus

It works, technically. But there is too much slop between the collars and the drill, which causes the drill to start eating away at the aluminum of the jig itself. Also, there is nowhere for the wood shavings to go, so they end up staying in the hole, having a party on spin cycle and overheating your drill bit. Finally, because the tolerances are so, the actually pocket hole you create is kind a hole surrounded by a bunch of torn wood.I used this for one project. Now it’s in the garbage and I bought something better, which amazingly, happens to actually work.

The product doesn't work without buying additional drill bits. The drill bits are too short to go in a drill and go through the hole in the pocket hole tool

not easy to use or accurate