Corner TV Wall Mount Full Motion Corner TV Mounts for 32-65 inch LCD LED OLED Flat Curved Screen TVs up to 99 LBS Articulating Corner Mount TV Bracket with Max VESA 600x400mm Swivel Rotate

The requirement for being 470mm away from the corner meant I needed to find studs within that area. Since I didn't find a stud within the bracket length beyond the 470mm away from the corners and I don't trust the plastic drywall inserts provided, I found my wall studs and mounted boards to those then mounted the bracket to the boards. The 470mm call out in the instructions is required for when the 65 inch TV is mounted. The TV sides sit flush against each wall when finally installed. The brackets on the back of the TV mount separately then the TV hangs off the top of the mounting bracket and is secured by two set screws. You'll need a level to ensure everything is horizontal before you mount the TV then again after the TV is mounted. You only get +/- 3 degrees to play with.Note 1: Forget the Hex/Lag bolts this comes with and buy 4"x 1/4" SPAX screws for the studs. Two per board (depending on if your walls don't have the studs like mine) and bracket mount is enough to hang off of (but don't because you'll break the mount).Note 2 (suggestion): If you have a cabinet that this installs above, with the TV sitting on the cabinet, measure the center of the TV mounting points, divide by 2, mark that spot on the TV, then measure from the floor up the cabinet and from the cabinet to your spot you marked. Add height for something like a sound bar. Use that measured height for the center of the bracket location on the wall to determine how high you need to mount the bracket which will be the center of the TV mounting point. -Assuming the mounting points on the TV are centered within the back of the TV.

The task of mounting our living room tv started like any other household chore with a loving text from my wife, “hey, can you order a tv mount so we can hang the tv like I asked you to do two months ago?” With a newfound motivation, I ordered this tv mount which showed up two days later (thanks amazon). I knew my package had arrived when my wife walked into the kitchen after returning from the grocery store and stated “I heard a loud bang and felt something as I pulled into the garage. You may want to go check it out.” I walked into the garage to find the package only slightly mangled by her 2015 Toyota Highlander (pictured below). Long story short, the tv stand survived without a scratch! It was literally run over and still works perfect!

Instructions kinda sucked just pics and small foot notes in the caption and you kids had to figure it out no biggy though I got it up sent only lags to mount so will need to get some of the toggle bolts to mount on sheetrock which is we're everyone mounts it no studs alined on mine at all and I can hang on it the mount is very strong and I'm sure I can hang two TV's on it all and all if your willing to buy the bolts to mount it it's a great mount

My brother helped me install this since I can't lift a TV over my head to mount alone. He's installed many tv wall mounts and the directions on this one were total garbage! But we figured it out regardless. One thing to note when you're installing is to make sure the part that adjusts the tilt of the tv is on the bottom, I have included a picture for reference. We first installed it on the top and the tv wouldn't stay in position, I also noticed some other reviews where it was on the top and they had the same problem and had to stick something in there to stop the tv from tilting down.

I hung my Samsung 40" in a corner up high. Use the hardware supplied and make sure you have all the tools you need before you get started. This is not a light unit. Make sure you attach to studs in wall. Make sure to use the level that comes with it and or your own for accuracy. Even though the unit is made to be flexible, I would not frequently adjust it because the bracket that is directly bolted to the wall receives the stress of movement. The flexible joints are stiff to move thus pulling on the bolts. However. in a beam or stud it is very secure. I love mine. It is serving it's purpose.

If you're looking for a corner mount, this is the one you want. I went to Best Buy to purchase one but they didn't have anycorner mounts so I knew Amazon would have some to choose from. After looking at the corner mounts available Iwent with this one. It's exactly as stated.....moves from side to side and tilts too. It's nice because there are two knobsthat you unscrew to put in exactly in the position you want it and then tighten the knobs. This way it won't move once it'sin place. I definitely recommend it.

It took my cousin and I to install but this is amazing and the best tv wall mount I’ve ever seen. I got one almost exactly like it only not fit corners for my bedroom. I love the choices and all the extensions it gives. Try it people, it is incredible. I change my rooms around with the seasons and the mounts make it possible to see tv from anywhere in the room!