Exhaust Hanger Muffler Bushing Mount Bracket Insulator 12mm 0.47" ID 6 Holes Rubber Universal Black

Bought this because the OEM hanger wasn’t long enough for the after market exhaust I put on. This hanger made a great substitute. Fit perfectly and helped solve my exhaust leak/security issues. Make sure to take the little metal piece out of the oem hanger and put it on this one for the screw to ensure extra security.

worked great

This fit exactly like the original. I just did it in the driveway and lubed it up with some sprayway glass cleaner. 2011 JAGUAR XJ

It's a tad smaller than the Jaguar brand however, it fits like a charm. I didn't use a jack to lift my car, the muffler hung down just enough to get my hands under and remove the old piece. Just a bit of push and pull. I used super lube on the new pieces and it definitely helps with mounting in on the hangers.

I recently bought a Tsudo Axle Back Exhaust for my 2016 Lancer GT, and to my surprise, it sat pretty close to the underside of the rear bumper. It sat so close, it actually burned and melted a small part of the bumper! So, from the recommendation I found online, changing the hanger bushing would do the trick. This hanger bushing fits perfectly for my Lancer and it actually lowered the exhaust tip about an inch away from the underside of my rear bumper! I still installed a heat shield just to be safe, but so far, there are no signs of burning or melting!

Worked just like it was suppose to. And way cheaper than what jaguar was trying to charge me for this same exact piece. Just wasn't red.

I replaced my stock exhaust on my lifted Jeep and ran into an issue where the stock hanger was too short! Purchased this not know if it was longer and it turned out to be exactly what I needed to keep my exhaust lifted.

works well for now time will tell.