Black 1" Motorcycle Handlebar Hand Grips w/Throttle Compatible with Sportster 883 Street Bike Dirt Bike Cruiser and Chopper (Black)

Had to sand down a burr on the throttle side but other than that fit great wife loves them

A part of the right grip got loose and was gone while i was driving.

Installation was very simple, however these grips are not of the greatest quality. The left one was so loose had to gorilla tape and gorilla glue to hold it on. The right one (throttle) would slip on the tube and also had to be gorilla glued. Look nice, but very poor craftsmanship.

I bought these grips for a 2015 Harley Sportster....if you have one...DO NOT buy these. My uncle and I were able to get them to work, but only after major modification/grinding and about an hours worth of time. The grips are to small on the inside to get a good adhesion to the handle bars and the flare at the end it to big to work with the factory setup on the non throttle side on the Harley. We had to grind almost all the flare off to make it set inside the recessed part of the blinker assembly like the factory grips from Harley. We honestly would have sent these back when we realized how much modification was needed but we had already taken off the factory grips and basically destroyed them to get them off so we didn't have much choice but to make these work.

The sizing was a little loose. Slipped on and off the left side too easily so I wrapped tape around the handle bar to hold it better. Throttle side is fine apart from the grip slipping around the throttle tube. Easily fixed with adhesive or hair spray.. all in all they’re comfortable

I attempted to buy another brand before as I was trying to avoid paying the $80-$100 on this style grips which I ended up returning nearly immediately. The throttle assist is adjustable since I didn’t see this listed anywhere and they fit like a glove in my new bars (1”). The clutch side I installed with a single layer of electrical tape and hairspray. If you go with something that expands like gorilla glue, be careful because it’s already a snug fit.

These feel insanely cheap. The rubber pads for the fingers aren't adhered in anyway to the outer housing. The clutch side doesn't have the tapered collar so gluing is the only way to get it to stay in place. That's fine and dandy except that while trying to glue in place, the unsecured rubber on the inside of the outer housing won't stay in place and rolls inside of itself. By the time it's in place, the pads are completely out of place and impossible to get back in without removing the outer housing and starting all over again. If I had to choose between wrapping my handle bars in barbed wire or ordering another set of these, I'd pick the barbed wire.

I was definitely looking forward to getting these I was tracking the location of the package I was so excited. However even though Amazon told me it fits my vehicle it actually did not. The clutch side fit perfect the throttle side fit however on the road Glides mine has a gear at the end of the handle this is supposed to catch on the end of the grip so when you turn the grip it actually accelerates the bike. It slipped over and bolted on however it does not fit tight enough to grip the throttle gear.

Muy mala calidad, no quedan bien además se les salen los hules negros , en pocas palabras no sirven!!! Gasto inútil!!

Los puños los tuve que pegar con un pegamento súper fuerte

Excelentes empuñaduras

Muy comodas, fáciles de poner compatibles con mi honda

Cambié los puños originales y estos son muy cómodos y lucen bien.