DEEPCOOL RGB 200 PRO Addressable RGB LED Strip Magnetic Lightning Kit - DP-LED-RGB200PRO

Item not working. Item low quality. Just waste my time on this.

This is a review for RGB 200PRO - as you can see in the images I attached above these are 3 pin RGB connectors which goes in your JRainbow connector of your motherboard.I'm using this on MSI B450 motherboard which has both 2x4pin 5050 RGB pin and 1x3 pin JRainbow RGB pin headers. Do not plug these in your 4pin RGB port or else you'll burn these strips as these are 5v 3pin and the 4pin RGB are 12v so you can see the difference of voltage it uses.okay now about the brightness... it's really bright, brighter than Corsair kits or almost the same but cheaper. it syncs perfectly with the Msi Mystic light and these strips has both magnetic and adhesive layer so you can stick them as you like. the adhesive is strong but the magnets are weak but not that weak that it will fall if you place on top of your case.I placed my strips without using the adhesive and the magnets sticks without any problem, doesn't fell even once (I did a shake test too)

I guess they do what they say. However I had to replace my first order as I got sent 2 pieces of roughly chopped cheap led light strips without connectors. However after I got refunded, I reordered and got working ones. They’re ARGB so they instantly sync with whatever lighting solution you have on your mobo. The adhesion is pretty good actually, and they are magnetic but not strong enough to hold their weight when place horizontally on the top of your case.Be sure to connect them to the 5V header and not the 12v one (it can damage the strips). Refer to your mobo manual or check the product page to find the 5V header (it’s usually on the bottom left side, right beside the 12v one) on my gigabyte gaming x v2, it was the D_LED header.

Nella build del nuovo computer ho preso più di un componente a marchio Deepcool e li ho trovati tutti ottimi e queste strisce Led ne confermano la bontà dei prodotti.Ottimi come adesione e sinceramente ne ho montato solamente uno perché associato agli altri componenti Argb creava una illuminazione troppo intensa.Nessun problema all’integrazione con il controllo dei colori ed effetti da parte del software della scheda madre che nel mio caso è una Asrock Taichi.

Amazing strips deepcool very underrated brand

Anche se avrei preferito delle strisce luminose omogenee (tipo neon per intenderci), purtroppo di addressable ho trovato solo queste. Tuttavia di ottima fattura, i led sono ben luminosi e riproducono tutto lo spettro RGB, ma il problema e stato installarle perché sia come calamita e sia come adesivo non attaccano bene, dopo una mezza giornata si staccano in tutti i modi, colpa della curvatura che le strisce formano nella confezione e del fatto che le abbia montate sopra rivolte verso il basso. Comunque ho dovuto fermarle con delle goccioline di colla a caldo lungo tutto il profilo.