POR-15 Bed Liner - Truck Bed & Underbody Coating - Black - 1 gl - Rust Protection & Impact Resistance

I sanded truck completely with 60 grit... sprayed with a bed liner gun and it looked great.... for 2 weeks... and the peeling has begun... I have contacted por15... I guess we will see what they will do... not holding my breath... as with all companies who claim they have the best products they don't back their product... I guess I will see...

Did the proper prep work. Sprayed on great with good coverage. Two weeks later the pealing started. Almost all came off. I have used Por15 before worked great but this stuff was bad.

I applyed this coatind as directed. The majority has peeled off 2 weeks later.

This stuff is Awesome! Bought a cheap spray gun and played with the pressure a bit and covered the entire inside of my Jeep Wrangler YJ with 2 coats...Unfortunately for me the following days had temps below 40 degrees and didn't allow this stuff to cure properly. The entire back half started to crack and peel. I waited till the spring, prepped the back half and was still able to spray 2 coats on the back half of the tub which finally used up the gallon. Still gets 5 stars as the cracking and peeling was on me and I would buy again without a doubt, just be mindful of ambient air temp (which is listed on the container).

Bought this one for one of our large flatbed trucks. Simply because the brand makes some other great products. We prepared the new steel bed exactly as per the instructions. Using only the POR products. Applied the bed liner coating. Looked good for a couple of days. Than bubbles started to build. More and more big blisters. After 5 days we the coating flaked off. Not sure what the heck went wrong. We also used another widely known truck bed coating available at stores all over. We used that in the past. That one is cheaper and worked great after we scraped the POR off.