Motoparty High Temp Exhaust Couplings Clamps 1"ID For Yamaha Banshee YZF350 YFS200 Raptor Blaster KX80 KX125 KX250 CR80 CR125 CR250 CR450 TRX250R CR KX RM FMF DG Quads Dirt Bikes(Black)

These caught on FIRE! Don't buy these.I had just finished my rebuild and I started my motorcycle up for the first time and after about 30 seconds, these caught on fire. Luckily I wasn't riding it at the time, but it's a huge safety issue. I was able to run and get a bucket of water, but the damage was already done. DON'T BUY THESE!!!

I installed the coupling and it looked good and i was satisfied with it until I drove down the road and back. I stopped to check amd make sure everything was still good and the silicone type layer was missing in a spot as big as a nickel and the braided rope stuff on inside was exposed. The second day i rode for a little while and it eventually started leaking through the rope style layer.. High temp is not able to with stand high temps obviousl. $15 dollar rip off in my opinion..

I had to construct a generator box and had the exhaust vented out the side. I used a flexible pipe to extend the muffler exhaust. This coupling worked perfect. Smoked a little at first but after an hour of monitoring, it works fine.

Very soft rubber material and 2 inches is just a little too short light duty low heat only.I Put it on the exhaust of an 80cc 2 stroke. it melted within 5 minutes!

These are very thin and stretchy and I was expecting it to last maybe an hour tops but I have been riding hard all week on it and has held up great so far. I hope it lasts!