LimbSaver Mini UltraQuad Dampeners, Black, 3-Pack

These make a great combination to add to the regular size Limbsaver

Good

Had very annoying clicking noise on my diesel heater fuel pump. Stuck three of these around pump and added a lightly tensioned zip tie. Cut down the noise significantly. Very happy with their addition to my diesel heater.

I have purchased the Limbsaver mini's before. The can be hidden on your bow just about anywhere. small enough to attach to your sight pin and not look out of place. My only complaint is that there are 3 in the pack. so you either have to many or not enough LOL.Make sure it is where you want it before you place it, once it is in place, you will need a crow bar to remove it.Made a noticable vibration diffrence in my PSE X-Force. I placed on each limb just in front of the cams,and one on my sight pin. Even my neighbor said he could hear the diffrence in the sound the bow made. Much more quiet.I like these alot better that the full size limbsaver vib dampners, they perform just as well, but are a quarter of the size. A must have for the serious archer.

I put these on my daughters barnett BCR recurve crossbow. It has thin limbs and these fit perfectly. They did take out alot of the vibration. I had to get 2 packs cause there are only 3 per pack. Put 4 on the limbs and 2 on the side plates behind the foot stirrup. Took about 5 minutes to install. Would definitely recommend.

These will fit on sights, rests or pretty much anywhere on your bow. They seem to help a bit and certainly do not hurt anything or add substantial weight. If you are trying to quiet your bow these are worth a shot.

These really dampen the vibration and noise on the crossbows!!

Heard great reviews for this product and I can't wait to use them. Thank you

The size of the dampeners are about the size of the Canadian Lonnie while the actual glue pad is only that of a dime, making it really versatile. You can stick it on pretty much anything and everywhere.These are fantastic if you run a rear stabilizer mount as you can stick one of these on the mount itself to take out some vibration. Same goes for the sight, putting one on the housing of the sight takes out a lot of the vibration that passes through the sight assembly. If you run a dovetail sight, you stick one of these on the dovetail, though my dove tail is too skinny for this.These are not that soft, and should do alright in the heat. The glue held up really well in the Canadian winter, so it will probably be fine anywhere. In terms of vibration dampening, I really cannot say much. My Hoyt Helix is already really dead in hand, but these little dampeners do make the bow a tad bit quieter. Without these dampeners my bow averaged 84 db, with these little guy my bow averaged 83 db. I installed 6 of these which dropped my bow by 1 db. Very satisfied.

Nothing bad to say about this product other than wishing it came more than just a 3 pack.