QEP 4" Continuous Rim Diamond Blade - For Wet Cutting of Ceramic Tile

I used this blade to cut 1/4” thick, 2 inch ceramic mosaics. Worked perfectly. Very precise cuts with no chipping. I use it with the 6 amp Hyper Tough 4 1/2” angle grinder from Walmart. Yes you can use this 4” blade on a 4 1/2” grinder. Worked great for cutting straight and curves for around a shower drain.

Replaced d/w and this exposed a gap between the edge of the d/w and kitchen floor. Needed to cut multiple 2 ½” inserts to fill in the gap. The usual snap & cut tool would not work effectively and buying/renting wet saw too costly. Used this in my angle grinder and the blade cut the ceramic tile without breakage. Unable to assess for a professional but a homeowner diy – a perfect tool addition.

Got good use from it. If I'd gotten a more expensive blade I probably would've had less issues with chipping, but as it was the chipping was minimal until the blade started going. Cutting slowly and steadily also helps prevent chipping. Got the job done, but if you're really wanting a clean cut go at least a tier higher in price.

This wheel wore out before i could finish trimming the edge of a single pre-fab quartz countertop so I had to get another (different!) wheel to finish this simple job.

I went fairly slow while cutting to avoid any chips, but this blade worked really well and left me with a pretty smooth edge that I was able to finish with a polisher. I'd buy it again.

Used this to cut ceramic, stone and glass backsplash tile. Cuts great

Works very well, I put it in my miter saw and use to cut decorative stone blocks for my stone walled gazebo. works very well.

These blade did the job no problem . Cut 1 inch granite with ease . Very Sooth cuts no chips at the edges at all.