5 Pieces 3D Body Shape Silicone Mold Goddess Female Male Model Body Stand Ornaments Resin Mold High Gloss Mirror Shiny Mold, Figure Casting Mould for DIY Jewelry Craft Making Decorations

I threaded the wick and went to pour and wax ended up everywhere I think thicker molds might be better to use. Luckily I was able to save the wax and put it into one of my other thicker molds.

I’ve wasted so much candle wax trying to make these molds work I really wanted to be able to use them they are beautiful but it is almost impossible to remove your candles once they have solidified

The figures are really varied. They are not the most difficult things I've tried to unmold but certainly not the easiest. I really do like them.

The molds were very easy to use. Getting the candle out was a headache. I used a 2inch Keith needle to pierce the mold which made a super tiny hole and a small suture wire to pass the wick through. I poured the wax into the molds at 125 degrees. I let them set for a few hours before removing them. I was able to get both molds easily pulled up about a half inch to an inch before they wouldn't easily go anymore. I struggled for awhile and even messed the candles up a little from trying to get them released. I put them in the freezer for about 30 minutes hoping that would work as I've heard people saying that could work. It didn't help. I finally had the cut the sides down to get them out thus ruining the product and wasting my money. I also hurt a couple of nails in the process. The finished product was ok after finally getting them out. You can see in the pics where wax was chipped. I think the molds overall are good just not for candles.

The media could not be loaded.  Difficult to remove the candle once hardened. I wished i had seen the reviews

The candles looks beautiful once its don't with the mold

It should not take over 20 minutes to try and get the candle out of its mold. Plus it was over a week late arriving to my home. I have other silicon molds that come out in like one minute . their material is too rigid and hard compared to other materials that are softer and more pliable.

The quality of the product is good. However, I was using them for candle making and it is very hard to get the candle out after they are made. Hopefully, the more I use them the easier it will get to remove candles.

You can barely get the candles out of the moulds as the silicone is really rigid. My fingers ache and it took me a couple of hours and the candles arms and stuff were broken because I literally had to yank the mould off. It doesn't fold back like others. I could barely turn it inside out initially to check the inside. Better versions available. Also, I'm sure one of them isn't correctly upright as one just kept toppling over.

Such a shame one went white and stretchy . The others stuck to my resin . I have used other molds and this has never happened before. Maybe just a bad batch . I have sent them back ripped and cut . Wasted a lot of resin as do batches of bodies. Gutted

I purchased this item for candle moulds but unfortunately have not been able to get the candles out successfully without them breaking. It's very difficult to remove the candle once it has set. It's a shame because the mould looks great.

Not advised to use if you’re thinking of using them for making candles! I’ve tried four blooming times now and each time they’ve snapped in half! Waste of time

I love this product I use them with wax, the end product is fab, very good quality product and fast delivery only downside for me is that they are ninja to demold- it may just be me