JYXindzkj Yoohey Metal 12 inch Drawer Slides, Ball Bearing Two Way Slide Track Rail 0.7 inch Wide 1 Pair

Excelente oroducto

These are quality units. Very happy with purchase.

Needed rails that I could use for a custom drawer that are going to be installed on the top of the drawer. These are going to be perfect.

I use these to install a sliding table under my desk. They work OK although they are so thin that installation was a little tricky. But anything thicker just wouldn’t work for my purposes. I’m happy with them and the usefulness of the sliding table.

First, you get 1 pair of slides, not 10 pairs as described. In the fine print it says 1 pair.These part that goes on the cabinet are longer than the original Ikea slides (the draw side fits fine), maybe they will last longer. They do lack the tabs that hold the slide straight in the cabinet, and screw hole to attach to the furniture. I will try and describe how I installed, it may look like a lot, but it is easy, simple on the 2nd slide.MARK THE FRONT AND BACK OF THE NEW SLIDES - the wider side of the slide has 2 holes (for the drawer screw) with an arrow pointing to the front.You need to remove the old slide(s) - save the screws.Make sure the sides slide are evenly together. Hold the slide in its general location, (make front and back slightly away from back and front of chassis), and mark as close as you can (use a black sharpie) the location of where the screw was (108462 or 100365) that you took out. Center punch this location on either of the sides of the slide (i used a small piece of wood to keep the slide from bending). Making sure the "black plastic insert" is not in the way, drill through both sides of the slide with a small drill bit. Open the slide, and enlarge hole on the narrower side of the slide so the screw 108462 100365 fits. enlarge the wider side hole so you can get a screwdriver in to turn the screw. Put the screw into the smaller side (with the head between the side of slide), close the slide, and tighten the screw into the hole.Use a combination square or speed square under the slide, and with a clamp hold the square in place so the slide is level. Double Check. Using the screws included with this slide, install a screw into the front and back of the slide using the predrilled holes on the narrow side of the slide (you will need to move the slide back and forth until you have an access hole).Put the drawer on the slides, and pull the slide to the front of the drawer, and push back a little(about 1/8 inch - wiggle room) Using a small bit (I used 1.5mm) drill a hole into the drawer using 1 of the 2 holes (near the arrow) - drill straight in. Now push the slide back a little more, and enlarge the hole in the draw to a little over 4MM (the screw is a 4mm screw), make the screw goes in easily. get rid of any bumps created by the hole, and clear out sawdust. position the slide so you can see through the hole in slide and drawer, and insert/tighten screw from the inside of the drawer. [Note if you are missing drawer screws, you can pick them up at the hardware store, they are M4 length=8mm, or 10mm will give you a handhold on the screw as you insert it into the drawer and line it up with the slide.I used: drill, bits, square (speed or combo), clamp screwdriver, bits.Like I said, it looks like a lot, but I tried to provide details so you won't be confused.